Method evaluation : Electrical surface resistance measurements on coated conductive textiles

This thesis has evaluated how electrical surface resistance can be measured on conductive coated textiles using two different probes. The electrical surface resistance is a measurement for how difficult it is for current to flow through a material. For textiles, the surface resistance can be measured using four metallic plates, that measure the difference between current supply and voltage drop, this method is called a linear four-point probe. There is no standard method for measuring the electrical surface resistance on conductive textiles. Therefore, it is not possible to compare textiles made by different producers. It is also not possible to decide what the true resistance is and as conductive textiles are becoming more popular to use, this has started to become a problem in the industry. Two probes with electrodes of different dimensions were used to evaluate how different electrodes would affect the measured resistance. Measurements were conducted on conductive coated textiles with varying parameters, like coating thickness, sample size and textile construction, to show how the electrical resistance properties differ depending on what probe was used. It was found that in contrast to other research on conductive textiles and collinear four-point probes, the probes used in this study could detect electrical anisotropic properties. The resistance was different depending on what angle it was measured in. This was found for both a thicker coating and a thinner one. It was also found that the probes could detect a correlation between the angular resistance and the textile construction used. By measuring the resistance on small samples with the same dimension as the probes electrodes, the resistance was increased compared to when measurements were conducted on samples with dimensions significantly larger than the probes. Furthermore, the results showed that increasing the distance between the inner electrodes of the probe decreased the measured resistance for both large and small samples. Additionally, it was found that by increasing the width of the outer electrodes the resistance was decreased, an increase in outer electrode width also made it easier to detect electrical anisotropic properties