Static and forward speed tests were made in a 40 multiplied by 80 foot wind tunnel of a large-scale, ejector-powered V/STOL aircraft model. Modifications were made to the model following earlier tests primarily to improve longitudinal acceleration capability during transition from hovering to wingborne flight. A rearward deflection of the fuselage augmentor thrust vector was shown to be beneficial in this regard. Other augmentor modifications were tested, notably the removal of both endplates, which improved acceleration performance at the higher transition speeds. The model tests again demonstrated minimal interference of the fuselage augmentor on aerodynamic lift. A flapped canard surface also showed negligible influence on the performanc...
The current program is aimed at providing a physical picture of the flow physics and quantitative tu...
The top level, time-phased total space program support system architecture is described including pr...
Several tests of the Rocketdyne configuration of the Space Shuttle Main Engine (SSME) High Pressure ...
All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as...
The effect of screens, honeycombs, and centrifugal blowers on the two-dimensionality of a boundary l...
Information is given in vugraph form on pilot procedures in windshear, typical winds in a downburst,...
A 0.165-scale isolated inlet model was tested in the NASA Lewis Research Center 8-ft by 6-ft Superso...
Tests were conducted in wind tunnels during April and May 1973, on an 0.030-scale replica of the Spa...
Spacecraft systems (fuel, electrical) are analyzed for performance prior to launch. Systems failures...
The effect of a leading edge flap on the aerodynamics of a low aspect ratio delta wing is studied an...
This report presents the tests results of a series of tests made of the sprays from 14 fuel injectio...
High bypass geared turbofan engines with nacelles forming the propulsion system for short-haul passe...
Tests carried out in November 1981 on the stationary flap of STOL test planes at Kakuda Labs are des...
All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as...
The SAFT prismatic VOS Ni-Cd cells have been flown in geosynchronous orbit since 1977 and in low ear...
The current program is aimed at providing a physical picture of the flow physics and quantitative tu...
The top level, time-phased total space program support system architecture is described including pr...
Several tests of the Rocketdyne configuration of the Space Shuttle Main Engine (SSME) High Pressure ...
All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as...
The effect of screens, honeycombs, and centrifugal blowers on the two-dimensionality of a boundary l...
Information is given in vugraph form on pilot procedures in windshear, typical winds in a downburst,...
A 0.165-scale isolated inlet model was tested in the NASA Lewis Research Center 8-ft by 6-ft Superso...
Tests were conducted in wind tunnels during April and May 1973, on an 0.030-scale replica of the Spa...
Spacecraft systems (fuel, electrical) are analyzed for performance prior to launch. Systems failures...
The effect of a leading edge flap on the aerodynamics of a low aspect ratio delta wing is studied an...
This report presents the tests results of a series of tests made of the sprays from 14 fuel injectio...
High bypass geared turbofan engines with nacelles forming the propulsion system for short-haul passe...
Tests carried out in November 1981 on the stationary flap of STOL test planes at Kakuda Labs are des...
All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as...
The SAFT prismatic VOS Ni-Cd cells have been flown in geosynchronous orbit since 1977 and in low ear...
The current program is aimed at providing a physical picture of the flow physics and quantitative tu...
The top level, time-phased total space program support system architecture is described including pr...
Several tests of the Rocketdyne configuration of the Space Shuttle Main Engine (SSME) High Pressure ...