Noise measurements were made to determine if recent modifications made to the bifurcated jetpipe to increase engine thrust had at the same time reduced the noise level. The noise field was measured by a 6-microphone array positioned on a 30.5m (100 ft) sideline between 90 and 150 degrees from the left engine inlet. Noise levels were recorded at three flap angles over a range of engine thrust settings from flight idle to emergency power and plotted in one-third octave band spectra. Little attenuation was observed at maximum power, but significant attenuation was achieved at approach and cruise power levels
Noise data with models of both internally and externally blown jet flaps designed for STOL aircraf
Jet flap interaction acoustic data obtained statically from a model-scale study of STOL-OTW configur...
Noise measurements were obtained on models of jet-augmented lift systems which are currently being c...
Static noise and performance tests were conducted on a 1/4-scale jet flap model with a multilobe noz...
Results are presented for full scale ground static acoustic tests of over-area conical nozzles and a...
Noise measurements were obtained on models of jet-augmented lift systems which are currently being c...
Interior and exterior fuselage noise levels were measured on NASA's C-8A Augmentor Wing Jet-STOL Res...
Flight tests were conducted in a CV-990 jet transport with engines at idle power to investigate airc...
The results of preliminary acoustic tests of the engine over the wing concept are summarized. The te...
An experimental investigation, conducted on a model-scale augmentor wing to identify the sources of ...
Static performance and acoustic tests were conducted on a two-dimensional one-third-scale augmentor ...
Variation in engine noise for two landing approach configurations of jet transport aircraf
An experimental study is presented of the pressure fluctuations near jet exhaust streams made during...
This program was undertaken to develop, through analysis, design, experimental static testing, wind ...
The technology of turbofan engine noise reduction is surveyed. Specific topics discussed include: (1...
Noise data with models of both internally and externally blown jet flaps designed for STOL aircraf
Jet flap interaction acoustic data obtained statically from a model-scale study of STOL-OTW configur...
Noise measurements were obtained on models of jet-augmented lift systems which are currently being c...
Static noise and performance tests were conducted on a 1/4-scale jet flap model with a multilobe noz...
Results are presented for full scale ground static acoustic tests of over-area conical nozzles and a...
Noise measurements were obtained on models of jet-augmented lift systems which are currently being c...
Interior and exterior fuselage noise levels were measured on NASA's C-8A Augmentor Wing Jet-STOL Res...
Flight tests were conducted in a CV-990 jet transport with engines at idle power to investigate airc...
The results of preliminary acoustic tests of the engine over the wing concept are summarized. The te...
An experimental investigation, conducted on a model-scale augmentor wing to identify the sources of ...
Static performance and acoustic tests were conducted on a two-dimensional one-third-scale augmentor ...
Variation in engine noise for two landing approach configurations of jet transport aircraf
An experimental study is presented of the pressure fluctuations near jet exhaust streams made during...
This program was undertaken to develop, through analysis, design, experimental static testing, wind ...
The technology of turbofan engine noise reduction is surveyed. Specific topics discussed include: (1...
Noise data with models of both internally and externally blown jet flaps designed for STOL aircraf
Jet flap interaction acoustic data obtained statically from a model-scale study of STOL-OTW configur...
Noise measurements were obtained on models of jet-augmented lift systems which are currently being c...