The aerodynamic performance of a redesigned compressor drive turbine of the gas turbine engine is determined in air at nominal inlet conditions of 325 K and 0.8 bar absolute. The turbine is designed with a lower flow factor, higher rotor reaction and a redesigned inlet volute compared to the first turbine. Comparisons between this turbine and the originally designed turbine show about 2.3 percentage points improvement in efficiency at the same rotor tip clearance. Two versions of the same rotor are tested: (1) an as cast rotor, and (2) the same rotor with reduced surface roughness. The effect of reducing surface roughness is about one half percentage point improvement in efficiency. Tests made to determine the effect of Reynolds number on t...
The stage group performance of a 4 1/2 stage turbine with an average stage loading factor of 4.66 an...
The turbine developed design specific work output at design speed at a total pressure ratio of 6.745...
The experimental performance of a modified turbine for driving a supersonic compressor is presented ...
The aerodynamic performance of the compressor-drive turbine of the DOE upgraded gas turbine engine w...
The aerodynamic performance of the inlet manifold and stator assembly of the compressor drive turbin...
A single-stage axial-flow turbine was investigated to determine the effect of increased stator throa...
The aerodynamic performance of the compressor-drive turbine of the DOE baseline gas-turbine engine w...
Modifying the original turbine by closing down the first-rotor throat area and shrouding the first a...
An air cooled version of a single-stage, axial-flow turbine was investigated to determine aerodynami...
The design of a single stage axial-flow turbine with a tip diameter of 11.15 cm is presented. The de...
A solid blade version of a single-stage, axial-flow turbine was investigated to determine its perfor...
Partial admission performance was obtained for a 0.4 linear scale version of the LF460 lift fan turb...
An 8.00-in mean diameter two-stage turbine was investigated over a range of speeds from 0 to 110 per...
The efficiency of a two-stage turbine is discussed. The turbine efficiency was 0.932 for equivalent ...
Results are presented for the design and development of an upgraded engine. The design incorporated ...
The stage group performance of a 4 1/2 stage turbine with an average stage loading factor of 4.66 an...
The turbine developed design specific work output at design speed at a total pressure ratio of 6.745...
The experimental performance of a modified turbine for driving a supersonic compressor is presented ...
The aerodynamic performance of the compressor-drive turbine of the DOE upgraded gas turbine engine w...
The aerodynamic performance of the inlet manifold and stator assembly of the compressor drive turbin...
A single-stage axial-flow turbine was investigated to determine the effect of increased stator throa...
The aerodynamic performance of the compressor-drive turbine of the DOE baseline gas-turbine engine w...
Modifying the original turbine by closing down the first-rotor throat area and shrouding the first a...
An air cooled version of a single-stage, axial-flow turbine was investigated to determine aerodynami...
The design of a single stage axial-flow turbine with a tip diameter of 11.15 cm is presented. The de...
A solid blade version of a single-stage, axial-flow turbine was investigated to determine its perfor...
Partial admission performance was obtained for a 0.4 linear scale version of the LF460 lift fan turb...
An 8.00-in mean diameter two-stage turbine was investigated over a range of speeds from 0 to 110 per...
The efficiency of a two-stage turbine is discussed. The turbine efficiency was 0.932 for equivalent ...
Results are presented for the design and development of an upgraded engine. The design incorporated ...
The stage group performance of a 4 1/2 stage turbine with an average stage loading factor of 4.66 an...
The turbine developed design specific work output at design speed at a total pressure ratio of 6.745...
The experimental performance of a modified turbine for driving a supersonic compressor is presented ...