Add to ORKGThe influence of different orifices on the result of measuring the same pressure distributions is the subject of this note. A circular cylinder is exposed to an air stream perpendicular to its axis and its pressure distribution is repeatedly determined. The pressures measured on the downstream half of the cylinder do not change for the orifice sizes used in the tests
Orifice-to-orifice inconsistencies in data acquired with an electronically-scanned pressure system a...
Orifice plates are commonly found in fluid measurement devices, piping systems, and engines. They a...
The object of this investigation was to compare the relative merits of eccentric and segmental orifi...
The influence of different orifices on the result of measuring the same pressure distributions is th...
The following report has been prepared for publication by the NACA. Suitable locations of orifices f...
Experiments were conducted to obtain information on the relationship between the coefficients for fl...
Orifice effect on heat transfer and pressure measurements in low density wind tunne
1.1. This investigation covers many aspects of flow measurement but is primarily devoted to the stud...
1.1. This investigation covers many aspects of flow measurement but is primarily devoted to the stud...
The measuring of compressed air, under high pressures, by means of observing the drop in pressure on...
For some time it has been known that the presence of a static pressure measuring hole will disturb t...
A thick orifice of a given diameter is one in which the length-diameter ratio exceeds that of a Brit...
Wing pressure distributions obtained in flight with flush orifice and external tubing orifice instal...
The tests described in this report were made to determine the error caused by using small tubes to c...
The effect of variations of orifice length to diameter ratio on spray characteristics was determined...
Orifice-to-orifice inconsistencies in data acquired with an electronically-scanned pressure system a...
Orifice plates are commonly found in fluid measurement devices, piping systems, and engines. They a...
The object of this investigation was to compare the relative merits of eccentric and segmental orifi...
The influence of different orifices on the result of measuring the same pressure distributions is th...
The following report has been prepared for publication by the NACA. Suitable locations of orifices f...
Experiments were conducted to obtain information on the relationship between the coefficients for fl...
Orifice effect on heat transfer and pressure measurements in low density wind tunne
1.1. This investigation covers many aspects of flow measurement but is primarily devoted to the stud...
1.1. This investigation covers many aspects of flow measurement but is primarily devoted to the stud...
The measuring of compressed air, under high pressures, by means of observing the drop in pressure on...
For some time it has been known that the presence of a static pressure measuring hole will disturb t...
A thick orifice of a given diameter is one in which the length-diameter ratio exceeds that of a Brit...
Wing pressure distributions obtained in flight with flush orifice and external tubing orifice instal...
The tests described in this report were made to determine the error caused by using small tubes to c...
The effect of variations of orifice length to diameter ratio on spray characteristics was determined...
Orifice-to-orifice inconsistencies in data acquired with an electronically-scanned pressure system a...
Orifice plates are commonly found in fluid measurement devices, piping systems, and engines. They a...
The object of this investigation was to compare the relative merits of eccentric and segmental orifi...