Report presents the results of a study of data obtained in the NACA full-scale wind tunnel concerning the effects of interference and of propeller operation on longitudinal stability and control. The data include pitching moments for various power conditions for airplanes with tails removed and with tails set at various stabilizer and elevator angles. A number of surveys of the dynamic pressure and the flow direction in the region of the horizontal tail surface are also included. Results are given for eight airplanes, including a model of a four-engine airplane tested both as a tractor and as a pushed and a model of two-engine pusher. The effects are shown of propeller operation on the downwash angles and the dynamic pressures at the tail a...
An experimental investigation was made in the Langley stability tunnel to determine whether the low-...
This investigation was carried out by the aerodynamic staff of the National Advisory Committee for A...
Wind tunnel tests of the 0.16-scale Douglas MX-656 model were made at low and high subsonic Mach num...
Data obtained in the A? A. C. A. full-scale wind tunnel concerning the e~ects of interference and of...
Report presents the results of a study of data obtained in the NACA full-scale wind tunnel concernin...
The results of wind tunnel tests for the determination of the effect of a jet on the lift and downwa...
This thesis is to be considered a continuation of the material presented in the paper by Dr. C. B. M...
Longitudinal stability and control characteristics of powered model of twin-propeller deflected-slip...
Results are given of a wind-tunnel investigation at a Reynolds number of 6.8 x 10(exp 6) to determin...
Results are presented of a wind-tunnel investigation of the longitudinal stability, control, and per...
Report presents the results of an investigation conducted in the Langley stability tunnel to determi...
The horizontal tail surfaces of a new airplane usually are proportional so that the curve of moment ...
The models designated "Torino 30, 31, 32" are horizontal tail surfaces of rectangular, triangular, a...
Results are presented of a wind-tunnel investigation to determine influence of the fuselage and tail...
Results are presented of a wind-tunnel investigation made to determine the influence of the fuselage...
An experimental investigation was made in the Langley stability tunnel to determine whether the low-...
This investigation was carried out by the aerodynamic staff of the National Advisory Committee for A...
Wind tunnel tests of the 0.16-scale Douglas MX-656 model were made at low and high subsonic Mach num...
Data obtained in the A? A. C. A. full-scale wind tunnel concerning the e~ects of interference and of...
Report presents the results of a study of data obtained in the NACA full-scale wind tunnel concernin...
The results of wind tunnel tests for the determination of the effect of a jet on the lift and downwa...
This thesis is to be considered a continuation of the material presented in the paper by Dr. C. B. M...
Longitudinal stability and control characteristics of powered model of twin-propeller deflected-slip...
Results are given of a wind-tunnel investigation at a Reynolds number of 6.8 x 10(exp 6) to determin...
Results are presented of a wind-tunnel investigation of the longitudinal stability, control, and per...
Report presents the results of an investigation conducted in the Langley stability tunnel to determi...
The horizontal tail surfaces of a new airplane usually are proportional so that the curve of moment ...
The models designated "Torino 30, 31, 32" are horizontal tail surfaces of rectangular, triangular, a...
Results are presented of a wind-tunnel investigation to determine influence of the fuselage and tail...
Results are presented of a wind-tunnel investigation made to determine the influence of the fuselage...
An experimental investigation was made in the Langley stability tunnel to determine whether the low-...
This investigation was carried out by the aerodynamic staff of the National Advisory Committee for A...
Wind tunnel tests of the 0.16-scale Douglas MX-656 model were made at low and high subsonic Mach num...