Predicting drug release from diazepam FDM printed tablets using deep learning approach: Influence of process parameters and tablet surface/volume ratio

The aim of this study was to apply artificial neural networks as deep learning tools in establishing a model for understanding and prediction of diazepam release from fused deposition modeling (FDM) printed tablets. Diazepam printed tablets of various shapes were created by a computer-aided design (CAD) program and prepared by fused deposition modeling using previously prepared polyvinyl alcohol/diazepam filaments via hot-melt extrusion. The surface to volume ratio (SA/V) for each shape was calculated. Printing parameters were varied including infill density (20%, 70% and 100%) and infill pattern (line and zigzag). Influence of tablet SA/V ratio and printing parameters (infill density and infill pattern) on the release of diazepam from printed tablets were modeled using self-organizing maps (SOM) and multi-layer perceptron (MLP). SOM as an unsupervised neural network was used for visualizing interrelation among the data, whereas MLP was used for the prediction of drug release properties. MLP had three layers (with structure 2-3-5) and was trained using back propagation algorithm. Input parameters for the modeling were: infill density and SA/V ratio; while output parameters were percent of drug release in five time points. The data set for network training was divided into training, validation and test sets. The dissolution rate increased with higher SA/V ratio, lower infill density (less than 50%) and zigzag infill pattern. The established ANN model was tested; calculated f 2 factors for two tested formulations (70.24 and 77.44) showed similarity between experimentally observed and predicted drug release profiles. Trained MLP network was able to predict drug release behavior as a function of infill density and SA/Vol ratio, as established design space for formulated 3D printed diazepam tablets