The effect of timber bands and columns on the seismic behaviour of rubble stone masonry: A numerical study on Nepal's proposition for reconstruction of residential buildings

This research investigates if confining rubble stone masonry by timber bands and columns increases resistance against earthquake loads, by performing a number of numerical analyses in the finite element software program Diana. In order to establish a reliable model, the input parameters are investigated by means of a literature study and sensitivity study. Additionally, the numerical model is validated by comparing the results to an analytical study. From the analytical study it is determined that the failure mechanisms are correctly estimated by the numerical analysis. However, differences between the values of ultimate strength and ductility were observed. The effect of the confinement is investigated by a pushover analysis on a shear wall with two different masonry tensile strengths: ft = 0.01 N/mm2 and ft = 0.03 N/mm2. These values are selected to show how such a small difference in tensile strength results in a different failure mechanism of the wall, and therefore results in a vastly different displacement capacity and ultimate strength. Additionally, a shear wall with and without a window opening is studied. If the building is constructed with extremely low-strength masonry (ft = 0.01 N/mm2), the timber frame confinement will increase the resistance of the wall (with or without window opening) against the pushover load. If the building is constructed with masonry having a tensile strength of 0.03 N/mm2 or higher, the confinement has a negative impact on the ductility of the closed wall. For the wall with window opening the confinement triples its ultimate strength. Weather a strong or a ductile structure is more desirable, depends on the demand with respect to the seismic spectrum. If the ground motion demands a strong structure, it is advised to confine the masonry with a timber frame consisting of four timber bands, and columns at each wall junction. The design of the timber frame as recommended by the Nepali building codes is determined to not be sufficient and must be altered in order to provide this positive impact on the structure’s resistance. Firstly, the columns must be placed at both sides of the band, instead of on the inner side only, to avoid eccentric loads on the bands. Secondly, the cross-sectional dimensions of the bands and columns must be increased avoid failure of the connections and splitting of the timber. Taking these aspects into account, a new design for the confinement method is presented in this study. The limitations of the conclusions of this research follow from the investigation of a single, in-plane wall only. One of the goals of the use of bands is to improve the box behaviour, for which the out-of-plane performance must be investigated. Moreover, an analysis on a three-dimensional structure is needed to fully answer the research question. In a three-dimensional study, the closed walls and walls with opening give a combined response to the load, therefore, the advantages and disadvantages of the confinement are combined as well.Civil Engineering | Structural Engineering | Hydraulic Structure