Effect of tool kinematics on the drilling forces and temperature in low frequency high amplitude vibration assisted drilling

1Defects associated with drilling of fiber reinforced polymers (FRPs) are of major economic and safety concerns for aerospace manufacturers. Delamination of layers and thermal damage of the matrix are the most critical defects associated with drilling of FRP laminates, which can be avoided by keeping the drilling forces and temperatures below some threshold levels. Vibration-assisted drilling (VAD) is an emerging drilling process that uses intermittent cutting to reduce the drilling forces and temperatures, and achieve easier chip removal compared to conventional drilling. In this paper an extensive experimental study has been conducted to provide insight into the effect of the tool kinematics corresponding to the VAD parameters (speed, feed, frequency and amplitude) on the geometry of the formed chip determined by the intersection of the trajectories of the cutting edges as well as on the drilling forces and temperature. The combinations of the VAD parameters used in this study were selected from ranges of speeds 6,000 rpm to 12,000 rpm, feeds 0.05 mm/rev to 0.15 mm/rev, frequencies 30 Hz and 60 Hz, and amplitudes 40 \u3bcm to 400 \u3bcm. The Amplitude and feed were found to have the most dominant effect on the VAD forces, while the feed and speed had the dominant effect on the VAD temperatures. The thermal performance of the VAD process was found to be enhanced by the formation of vortices in the air gap created by the separation between the tool and the machined surface, which is mainly controlled by the feed and the rotational speed of the tool.Peer reviewed: YesNRC publication: Ye