Experimental investigation of load distribution in a composite girder bridge at elastic versus inelastic states

Bridge design and evaluation involve the determination of the internal forces and moments that each bridge element must resist. In slab-on-girder bridges, the moment and shear caused by traffic loads are normally determined using load distribution factors. These factors are derived based on results of analytical models, numerical analyses, as well as actual loading tests, but there appears to be scant experimental data to gauge their accuracy, particularly beyond the elastic limit state. To address the scarcity of the experimental data and to understand how the distribution characteristics of concrete slab on steel girder composite bridges change with the advent of yielding and inelasticity, a 1/3 scale model of a hypothetical composite bridge was tested to failure in this study.Extensive measurements were taken during the test to allow better understanding of the response of slab-on-girder bridges as well as their live load distribution characteristics at all stages of loading up to failure. The experimentally determined distribution factors for the tested bridge model are compared with the calculated values based on the Canadian Highway Bridge Design Standard, and the code values are found to overestimate the maximum moment in the interior loaded girder by about 22% and 33% at the elastic and the inelastic states, respectively. \ua9 2012 Elsevier Ltd.Peer reviewed: YesNRC publication: Ye