Effect of surface preparation on bond strength of resin luting cements to dentin

This study examined the effects of using two different burs for dentin surface preparation on the microtensile bond strength (μTBS) of three resin luting cements. Flat, deep dentin surfaces from 45 extracted human third molars were divided into three groups (n=15) according to bur type: (i) diamond bur and (ii) tungsten carbide bur. The controls were abraded with #600-grit SiC paper. Both burs operated in a high-speed handpiece under water-cooling. Composite blocks were luted onto the dentin using one of three cements: RelyX ARC (ARC, 3M ESPE), Panavia F2.0 (PF, Kuraray) and RelyX Unicem (UN, 3M ESPE) following the manufacturers' instructions. For ARC, the dentin surface was treated with 32% phosphoric acid. The bonded specimens were stored at 37°C for 24 hours and sectioned into 0.9 × 0.9 mm beams for μTBS testing. The data were analyzed using the two-way ANOVA and StudentNewman-Keuls tests. Representative fractured beams from each group were prepared for fractographic analysis under SEM. Two-way ANOVA revealed that the effects of "dentin surface preparation" and "luting cement" were statistically significant (p0.05). ARC showed no significant difference in μTBS among the three differently prepared dentin surfaces. The μTBS of PF and UN was significantly lower when bonding to dentin prepared with a diamond bur (p