Experimental study of the injection conditions influence over n-dodecane and diesel sprays with two ECN single-hole nozzles. Part I: Inert atmosphere

In this research, two Engine Combustion Network (ECN) mono-orifice nozzles, referred to as Spray C and Spray D. respectively, were analyzed by performing visualization tests through Schlieren and Diffused Backlight Illumination (DBI) techniques under a wide range of ambient conditions in a non-reactive atmosphere. Spray C presents a straight nozzle designed with a sharp fillet in opposition to Spray D that has similar hydraulic properties, but with a convergent nozzle construction and a smoother corner. The experiments were carried out injecting two distinct fuels at different injection pressure ranges, from 50 MPa to 150 MPa with n-dodecane and to 200 MPa for diesel. The images were processed with Matlab home-built routines to calculate parameters as spray penetration, spreading angle, quasi steady liquid length, as well as the spray penetration derivative respect to the square root of time, presented in this document as R-parameter. The results showed a clear influence of nozzle geometry in all measured parameters, due mainly to the nature of Spray C to cavitation, which increase the spreading angle and consequently a reduction in vapor penetration. On the other hand, fuel properties also affected spray penetration due to its dependency on viscous forces expressed in terms of the Reynolds number and its volatility in case of liquid length. This last parameter was calculated employing two processing methodologies, finding a good general agreement between them.This work was supported by "Ministerio de Economia y Competitividad" of the Spanish Government in the frame of the projects "Estudio de la interaccion chorro-pared en condiciones realistas de motor", Ref. TRA2015-67679-c2-1-R. Moreover, the optical equipment employed in the project was purchased with investment from "Ministerio de Economia y Competitividad" FEDER-ICTS-2012-06.Gimeno, J.; Bracho Leon, G.; Marti-Aldaravi, P.; Peraza, JE. (2016). Experimental study of the injection conditions influence over n-dodecane and diesel sprays with two ECN single-hole nozzles. Part I: Inert atmosphere. Energy Conversion and Management. 126:1146-1156. doi:10.1016/j.enconman.2016.07.077S1146115612