Synthesis of highly brominated diphenyl ethers and aspects on photolysis and indoor spreading

Abstract Adding chemicals to materials to decrease flammability can be dated back to as early as 450 BC when the Egyptians used alum to reduce flammability of wood. Almost 2500 years later brominated flame retardants (BFRs) are used to prevent ignition of textiles, electronics and polymers. BFRs in major use today are polybrominated diphenyl ethers (PBDEs), hexabromocyclododecane (HBCDD) and tetrabromobisphenol A (TBBPA), including derivatives. There have been three industrial PBDE mixtures produced. Extensive scientific reporting has shown increasing concentrations of PBDEs in wildlife and in humans. This in combination with reports on their physico-chemical characteristics and chemical reactivity have led to that two of the PBDE products have been classified as being persistent, bioaccumulative and toxic, which has led to legislative measures, in e.g. EU, Norway and the USA. The availability of pure reference standards is a prerequisite for much toxicologically related research. Hence the main objective of this thesis was to develop additional methods for synthesis of highly brominated diphenyl ethers. Further, to quantify and identify photolysis products of decabromodiphenyl ether (decaBDE) and to perform a case study regarding PBDE exposure in aircrafts. Synthesis of highly brominated BDE congeners by perbromination of mono-or diaminodiphenyl ethers followed by diazotization of the amino group(s) and introduction of hydrogen(s) in the molecules is a convenient route for synthesis of some octaBDEs and all nonaBDEs. Selective bromination of diaminodiphenyl ether, followed by diazotization of the amino groups and substitution with bromines yielded a hexaBDE or a heptaBDE which were then further brominated to octaBDE congeners. Even though several studies have been performed on photolysis of decaBDE a new study with a more quantitative approach was performed as part of this thesis. Debrominated PBDE products were identified and quantified and a marker PBDE for UV degradation of DecaBDE was identified i.e., The present thesis has contributed to make higher brominated diphenyl ethers available as reference standards, allowing better quantitative assessments possible regarding both abiotic studies and exposure assessments. New toxicological testing can also be pursued