New insight on studying the effect of both chemical sensitivity and rock mechanical properties in shale formation to minimize wellbore instability problems

Historically, many of the wells drilled in in shale formations have experienced a significant rig downtime due to wellbore instabilities. Most of the instability problems originated from the encountered shale formations. The objectives of this study include (1) to measure the properties governing shale strength and drilling fluid/shale interaction, and (2) to establish a reliable and efficient rock mechanical testing procedures related to wellbore stability. Preserved shale core has been recovered from shale formation and special core handling procedure was implemented. Mineral oil was used for plugging and core preservation. Rock mechanical characterization was conducted on core samples using both XRD/SEM techniques to study the core mineralogy. In addition, shale permeability was determined by two methods: flow testing and pressure transition methods. The results indicated that shale has high percentage of quartz (30-40%) which causes the shale to have high porosity and high permeability. The unconfined compressive strength of shale is very low which any drilling fluid that contains water phase further reduces. The Young’s modulus is very low which makes near wellbore deformation high. Based on the shale swelling testing, the all-oil fluid show no volume change occurred to the shale. When the same shale was exposed to the 7% KCl, about 16% increase in core volume occurred in 48 hours. This means that all samples allowed the water to flow into the shale formation