In this work, methods and procedures are investigated for the holistic simulation of the dynamicalthermal behavior of high-performance optics like lithography objectives. Flexible multibody systems in combination with model order reduction methods, finite element thermal analysis and optical system analyses are used for transient simulations of the dynamical-thermal behavior of optical systems at low computational cost
Thermo-optic phase shifters allow one to dynamically tune and control the operation of integrated-op...
Computational heat transfer analysis often involves moving fluxes which induce traveling fronts of p...
A new family of lighting products is developed as laser diodes replace LEDs in the remote phosphor c...
In this work, methods and procedures are investigated for the holistic simulation of the dynamicalth...
Thermal lensing in optical systems for laser beam guiding and shaping is a highly up-to-date topic t...
In high-performance optical systems, small disturbances can be sufficient to put the projected image...
At high average power, ultra-short laser pulses (<1 ps) are not only affected by dispersive effects ...
Increasing laser beam qualities make thermal lensing again a hot topic and demand for a thermo-optic...
Available from VNTIC / VNTIC - Scientific & Technical Information Centre of RussiaSIGLERURussian Fed...
The effect of dynamic optical properties on the spatial distribution of light in laser therapy is st...
A mathematical model of an adaptive optics system was described in the article. The model included t...
The performance of as-built optical instruments strongly depends on thermal and structural loads, si...
This work describes a development of a simulation tool predicting the performance of a high-power la...
Computational heat transfer analysis often involves moving fluxes which induce traveling fronts of p...
Thermo-optic phase shifters allow one to dynamically tune and control the operation of integrated-op...
Thermo-optic phase shifters allow one to dynamically tune and control the operation of integrated-op...
Computational heat transfer analysis often involves moving fluxes which induce traveling fronts of p...
A new family of lighting products is developed as laser diodes replace LEDs in the remote phosphor c...
In this work, methods and procedures are investigated for the holistic simulation of the dynamicalth...
Thermal lensing in optical systems for laser beam guiding and shaping is a highly up-to-date topic t...
In high-performance optical systems, small disturbances can be sufficient to put the projected image...
At high average power, ultra-short laser pulses (<1 ps) are not only affected by dispersive effects ...
Increasing laser beam qualities make thermal lensing again a hot topic and demand for a thermo-optic...
Available from VNTIC / VNTIC - Scientific & Technical Information Centre of RussiaSIGLERURussian Fed...
The effect of dynamic optical properties on the spatial distribution of light in laser therapy is st...
A mathematical model of an adaptive optics system was described in the article. The model included t...
The performance of as-built optical instruments strongly depends on thermal and structural loads, si...
This work describes a development of a simulation tool predicting the performance of a high-power la...
Computational heat transfer analysis often involves moving fluxes which induce traveling fronts of p...
Thermo-optic phase shifters allow one to dynamically tune and control the operation of integrated-op...
Thermo-optic phase shifters allow one to dynamically tune and control the operation of integrated-op...
Computational heat transfer analysis often involves moving fluxes which induce traveling fronts of p...
A new family of lighting products is developed as laser diodes replace LEDs in the remote phosphor c...
DOI
Add to ORKG