Experimental Investigation on Flame Characterization and Temperature Profile of Single/Multiple Pool Fire in Cross Wind

An experimental study was carried out to investigate the flame characterization and temperature profile for single and multiple pool fire with the influence of cross wind. There were 13 test cases in total, categorized into circle and rectangle fuel pans, with diameter (or equivalent diameter) ranged from 50 mm to 300 mm. Kerosene was used for the fuel of pool fire. Some K-type thermocouples were arranged around the flame to monitor the flame temperature, while the flame tilt angle was measured based on the photograph of flame for different case. Firstly, it can be found that there are three phases, including preheating, steady burning and extinguishing phase, during the flame evolution. The maximum temperature near the fuel surface is similar to 1040 K, which is higher than that of flame plume (similar to 600 K), in the steady burning phase of circle single pool fire (D=300 mm), while the average burning rate is similar to 1.525 g/s. In addition, the burning rates of all cases were measured and compared with the current predicted method. Typically, the flame morphology of single/multiple pool fire at different cross wind speed (ranging from 0 to 3.5 m/s) was analyzed, and it is found that the results for single pool fire agree with Thomas model and AGA model well, which are not suitable for multiple pool fire. Finally, the temperature profile of different case was measured with various wind speed