Effect of nitrogen content on microstructure and corrosion resistance of sputter-deposited multicomponent (TiNbZrTa)Nx films

Multicomponent (TiNbZrTa)Nx films were deposited on Si(100) substrates at room temperature using magnetron sputtering with a nitrogen flow ratio fN [fN = N2/(Ar + N2)], which was varied from 0 to 30.8%. The nitrogen content in the films varied between 0 and 45.2 at.%, i.e., x = 0 to 0.83. The microstructure was characterized by X-ray diffraction and electron microscopy. The metallic TiNbZrTa film comprised a dominant bcc solid-solution phase, whereas a single NaCl-type face-centred cubic structure was observed in all nitrogen-containing films (TiNbZrTa)Nx. The mechanical, electrical, and electrochemical properties of these films varied with nitrogen content. The maximum hardness was achieved at 22.1 ± 0.3 GPa when N = 43.0 at.%. The resistivities increased from 95 to 424 μΩcm with increasing nitrogen content. A detailed study of the variation of morphology and chemical bonding with nitrogen content was performed and the corrosion resistance of the TiNbZrTa nitride films was explored in 0.1 M H2SO4. While all the films had excellent corrosion resistances at potentials up to 2.0 V vs. Ag/AgCl, the metallic film and the films with low nitrogen contents (x < 0.60) exhibited an almost stable current plateau up to 4.0 V vs. Ag/AgCl. For the films with higher nitrogen contents (x ≥ 0.68), the current plateau was retained up to 2.0 V vs. Ag/AgCl, above which a higher nitrogen content resulted in a higher current. The decrease in the corrosion resistance at these high potentials indicate the presence of a potential-dependent activation effect resulting in an increased oxidation rate of the nitrides (present under the passive oxide film) yielding a release of nitrogen from the films. TEM results indicate that the oxide layer formed after this corrosion measurement was thick and porous for the film with x = 0.76, in very good agreement with the increased corrosion rate for this film. The results demonstrate that an increased nitrogen content in (TiNbZrTa)Nx system improves their mechanical properties with retained high corrosion resistance at potentials up to 2.0 V vs. Ag/AgCl in 0.1 M H2SO4. At even higher potentials, however, the corrosion resistance decreases with increasing nitrogen concentration for films with sufficiently high nitrogen contents (i.e. x ≥ 0.68).Funding agencies: VINNOVA Competence Centre FunMat-II (grant no. 2016-05156), The Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linköping University (Faculty Grant SFO-Mat-LiU No. 2009 00971), M – ERA.net (project MC2 grant no. 2013-02355), The Knut and Alice Wallenberg Foundation through the Wallenberg Academy Fellows program (P.E.) and the Electron Microscopy Laboratory at Linköping University, The Swedish Research Council VR Grant 2018-03957, The VINNOVA Grant 2018-04290, The Åforsk Foundation Grant 16-359, Carl Tryggers Stiftelse contract CTS 17:166, VR-RFI (contracts #821-2012-5144 & #2017-00646_9), The Swedish Foundation for Strategic Research (SSF, contract RIF14-0053)