From O2/CO2 to O2/H2O combustion: The effect of large steam addition on anthracite ignition, burnout and NOx formation

9 figures, 2 tables.-- © 2020. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/Steam-moderated combustion has been proposed to supress flue gas recycling in oxy-fired units, but the influence of replacing CO2 by H2O has to be deeply studied. In this paper, oxy-fuel combustion of anthracite with large steam addition has been experimentally characterized, and main results are discussed as concerns the influence upon the ignition temperature, the burnout and the NOx formation. The tests have been carried out in an electrically-heated entrained flow reactor for a set of O2/CO2 and O2/H2O/CO2 atmospheres, with steam addition up to 40% vol. The results show that ignition temperature diminishes when steam is added in low rates (maximum decrease of 16 °C), but the trend is reversed for the higher steam concentrations (maximum increase of 18 °C). The effect of steam addition on coal burnout rates is more significant for the 21% vol. O2 atmosphere, with a decrease of 2.2–5.3 percentage points, and almost negligible for the 35% vol. O2. An outstanding reduction of NO specific emissions is detected when adding H2O, with decrements ranging 28–45% compared to the dry conditions. The transition from O2/CO2 combustion to O2/H2O combustion barely affects the anthracite conversion but significantly diminishes NOx formation rates.The work described in this paper has been funded by the R + D Spanish National Program from the Spanish Ministry of Science, Innovation and Universities, under the Project ENE2015-67448-C2-2-R and the Grant BES-2016-078573. The Service of Electronic Instrumentation (University of Zaragoza) is also acknowledged for their support in the development of the SCADA at the experimental facility.Peer reviewe