Blends of bisphenol-A polycarbonate and acrylic polymers .2. PC/acrylic copolymers as a new route for compatibilization

An acrylic polymer containing acid and anhydride units, referred to as reactive polyglutarimide (RPGI), has been used to react with PC. The reaction has been previously determined as an acidolysis of the carbonate bond which breaks the PC chain in two parts. One of those two parts remains free while the other one is grafted on the acrylic backbone. We have found that the anhydride units could also react with the carbonate bonds. In this case the PC macromolecule would also be broken in two parts, which would, however, both be grafted on the acrylic backbone. The reaction has been performed in solution in order to keep good contact between the reacting units. The influence of temperature and concentration on the grafting ratio has been studied. The best experimental conditions were determined in order to obtain a grafted copolymer where the acrylic backbone only supports, on the average, one PC side chain through acid reaction or two PC chains through anhydride reaction. Indeed, these two types of reactions could not be isolated. The efficiency of this copolymer as emulsifier has been studied in solution cast blends as well as in melt mixed blends. The copolymer strongly affects the microstructure in solution cast blends where films containing 30 wt % of PC have become transparent. However, the dispersed phase size of solvent cast blends could be highly influenced by the casting conditions related to solvent trapping. In melt mixed samples, the copolymer also reduces significantly the dispersed phase size, but no transparent blends have been observed so far. These results were compared with those given in the literature describing the efficiency of a synthesized copolymer which has a more complicated structure. (C) 1997 John Wiley & Sons, Inc