Design of the Compact Processing Module for the ATLAS Tile Calorimeter

The LHC will undergo a major upgrade in 2025 towards the High Luminosity LHC (HL-LHC) to increase the current instantaneous luminosity by a factor of 5 to 7 times. The Phase-II Upgrade will accommodate the trigger and readout electronics of the ATLAS experiment to operate with the stringent requirements imposed by the HL-LHC. During the Long Shutdown 3 (2025-2027), both on- and off-detector readout electronics of TileCal will be completely replaced with a new data acquisition which will provide full-granularity information to the ATLAS trigger system. The Compact Processing Modules are responsible for the LHC bunch-crossing clock distribution towards the detector, data acquisition, cell energy reconstruction and data transmission to the TDAQ interface (TDAQi). The CPM has been designed as an AMC form-factor board equipped with 8 Samtec FireFly modules for the on-detector communication, a Xilinx Kintex UltraScale FPGA for data acquisition and processing, a Xilinx Artix 7 FPGA for slow control and monitoring, and other subsystems to generate high-quality clocks for the FPGAs and communications.%for data buffering, online digital processing and on-detector electronics control. The high-speed communication with the on-detector electronics is implemented via 32 GigaBit Transceiver links receiving detector data at 9.6 Gbps and transmitting commands and the LHC clock at 4.8 Gbps, while the reconstructed cell energies are transmitted to TDAQi is performed via 4 FULL-mode links. Triggered data is transmitted through a FULL-mode link to the FELIX system in the ATLAS TDAQ system. This paper introduces the design of the Compact Processing Modules for the ATLAS Tile Calorimeter Phase II Upgrade, and the results and experiences with the first prototypes