Effects of toothbrushing on surface characteristics of microhybrid and nanofilled resin composites following different finishing and polishing procedures

Objectives: To evaluate the effects of simulated tooth brushing (STB) on the surface roughness of microhybrid and nanofilled resin composites following different finishing and polishing procedures. Materials and methods: Ninety cylindrical-shaped specimens of Filtek Supreme XT (a universal nano resin composite) and Filtek Z250 (a universal microhybrid resin composite) were prepared. The specimens were allocated at random into 9 paired groups each of 10 specimens. The finishing and polishing systems included were Tungsten Carbide bur (TC); Diamond bur (Db); Sof-Lex discs (S); PoGo discs (PG); TC + S; Db + S; TC + PG; Db + PG. Polymerisation against a Mylar strip without finishing and polishing acted as the control. Surface roughness was measured using a 3D non-contact optical profilometer and surface morphology was examined by scanning electron microscopy. Specimens were subjected to the equivalent of four years STB and surface roughness was measured again. Results: Mylar formed surfaces were the smoothest for both composites before and after STB. Finishing with the diamond finishing bur caused significantly greater surface irregularity (p < 0.0001) before and after STB compared to the tungsten carbide bur. The surface treatment with Db + PG resulted in significantly greater surface roughness following STB than all other regimes of finishing and polishing (p < 0.01). Conclusion: Where indicated clinically, finishing is better conducted using a tungsten carbide bur rather than a diamond finishing bur. The combination of tungsten carbide bur/Enhance PoGo and tungsten carbide bur/Sof-Lex surface protocols produced a similarly smooth finish for both composites. The composite surfaces in all groups increased in surface irregularity following STB. CLINICAL SIGNIfiCANCE: Whilst finishing using a tungsten carbide finishing bur followed by either the Sof-Lex or PoGo polishing system may be found to result in a smooth surface finish, all the surfaces investigated increased in surface roughness following toothbrushing.This article is available to RD&E staff via NHS OpenAthens (Full text delays may apply). Click on the Publisher URL, and log in with NHS OpenAthens if prompted.published version, accepted version (12 month embargo), submitted versio