Device development for automatic assembly of bearings and drum spider brackets for the asko washing machine

V magistrskem delu je opisan potek snovanja in koncipiranja naprave za avtomatsko vgradnjo krogličnih ležajev SKF 6206-2RS1 in SKF 6207-2RS1 v sedež ležaja, ki je izdelan na spodnji in zgornji strani križa pralnega stroja WM-70 in WM-80 znamke ASKO. V uvodnem delu magistrskega dela je predstavljen in opisan zahtevnik, ki ga mora naprava izpolniti. Predstavljene so metode, s katerimi smo prišli do konceptnih rešitev delnih funkcij naprave. Sledi tehnično in ekonomsko ovrednotenje variantnih rešitev ter izbira najboljše variantne rešitve. Magistrsko delo spremlja še zagonski elaborat projekta, v katerem so med drugim zabeleženi vsebina projekta, cilji projekta, taktika izvedbe projekta in načrt izvedbe projekta. Zagonski elaborat celotnega projekta je namenjen učinkoviti in organizirani izvedbi celotnega projekta.The master\u27s thesis describes the design and conceptualization of the device for automatic installation of ball bearings SKF 6206-2RS1 and SKF 6207-2RS1 in the bearing seat, which are made on the lower and upper side of the drum spider brackets WM - 70 and WM - 80 brand ASKO. The introductory part of the master\u27s thesis presents and describes the requirements that the device must meet. The methods by which we came to the conceptual solutions of partial functions of the device are also presented. This is followed by technical and economic evaluation of variant solutions and selection of the best variant solution. The master\u27s thesis is accompanied by an initial study of the project, which records, among other things, the content of the project, project objectives, project implementation tactics, and project implementation plan. The start-up study of the entire project is intended for the efficient and organized completion of the entire project