Add to ORKGThis paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic waste solution, obtained in the conventional electrolytic copper refining process. The copper anodes with non-standard nickel, lead, tin and antimony content were specially prepared for the refining process. Nickel content of all anodes was approximately 7.5 mass %, and the content of lead, tin and antimony was varied. It was observed, that anodes with O2 content lower than 200 ppm, were not passivated. Results, obtained using the standard electrochemical techniques, have indicated that the anodes with non-standard chemical composition could be used under the same conditions as well as in the conventional copper refining process
Copper anodes with non-standard nickel, lead, antimony and thin content are used for refining by the...
The electrorefining process of the non-commercial Cu anodes was tested on the enlarged laboratory eq...
It is known that lead anodes used in the industrial extraction of copper by electrolysis (electrowi...
This paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic w...
This paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic w...
In this paper are presented the results of the first appearance of full pasivation during the treatm...
The use of copper anodes with non standard content of impurities for the treatment of waste, sulphur...
This paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic w...
The electrorefining process of the non-commercial Cu anodes was tested on the enlarged laboratory eq...
The aim of this paper was to investigate the possibility of using the copper anodes with high nickel...
This paper is adresses on treatment of sulphuric acid waste solutions obtained during the convention...
The use of copper use in electronics sets the electrorefining process as the basic method to produce...
Copper anodes with non-standard nickel, lead, antimony and thin content are used for refining by the...
The electrorefining process of the non-commercial Cu anodes was tested on the enlarged laboratory eq...
It is known that lead anodes used in the industrial extraction of copper by electrolysis (electrowi...
This paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic w...
This paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic w...
In this paper are presented the results of the first appearance of full pasivation during the treatm...
The use of copper anodes with non standard content of impurities for the treatment of waste, sulphur...
This paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic w...
The electrorefining process of the non-commercial Cu anodes was tested on the enlarged laboratory eq...
The aim of this paper was to investigate the possibility of using the copper anodes with high nickel...
This paper is adresses on treatment of sulphuric acid waste solutions obtained during the convention...
The use of copper use in electronics sets the electrorefining process as the basic method to produce...
Copper anodes with non-standard nickel, lead, antimony and thin content are used for refining by the...
The electrorefining process of the non-commercial Cu anodes was tested on the enlarged laboratory eq...
It is known that lead anodes used in the industrial extraction of copper by electrolysis (electrowi...