Electrochemical Noise: A Clear Corrosion Signature

The interpretation of electrochemical noise (EN) data has long been under discussion. Throughout the years, many data analysis techniques have been proposed for this purpose. As a starting point, procedures and parameters that enable identification of, or discrimination between, general and localized corrosion processes through EN are critically discussed. It is important to consider which type of information is required for a specific application. EN can be used to determine the barrier properties of a protective coating, and can therefore provide quantitative information about corrosion processes, although its most interesting ability is to provide information on corrosion characteristics. EN signals consist of a direct current (DC) component, or trend, with superimposed fluctuations. In electrochemical potential noise (EPN), this DC component represents the open corrosion potential (OCP) of the system under study. In electrochemical current noise (ECN), the DC component can e.g. be generated by electrode asymmetry. Any DC drift should be carefully removed prior to further data analysis. A procedure is introduced to accurately define the DC drift in EN signals using either of two time-frequency data analysis techniques: discrete wavelet transform (DWT) or empirical mode decomposition (EMD). Consistent and reliable information can be obtained from EN data when a data analysis procedure is selected that on the one hand has a high discrimination ability and on the other hand yields a descriptive parameter that is directly associated to the underlying physico- chemical process. Preferably, the information is obtained without the need for subjective a-priori limitations or assumptions concerning the nature of the process under investigation. These requirements are met by the Hilbert-Huang transform, which is based on the EMD. The result is a Hilbert spectrum in which local frequency information, so-called instantaneous frequencies, of EN signals, is visualized. The use of Hilbert spectra for the characterization of EN data in corrosion studies is introduced, based on the (general and localized) corrosion characteristics of carbon steel and stainless steel AISI304. A highly detailed decomposition of the original ECN and EPN data is provided in time and frequency simultaneously. This allows distinguishing between different corrosion characteristics based on their EN signals. Hilbert spectra also provide the possibility to analyze only transients present in the EN signals that originate from localized corrosion processes on AISI304. Initial identification of transients is based on the transient shape. Analysis of instantaneous frequency information present in these transients enables improved differentiation between corrosion characteristics as compared to data analysis using Hilbert spectra or energy distribution plots (determined from DWT) without transient analysis. The applicability of transient analysis through Hilbert spectra of ECN signals is further investigated for Ce-based inhibition of aluminium alloy AA2024-T3 and for detection and identification of microbiologically influenced corrosion (MIC). Transient analysis allows detection of changes in corrosion characteristics, i.e. the evolution of corrosion inhibition of AA2024-T3 by Ce-ions, with time. The initial procedure of transient detection is further developed, comprising of automatic detection of specific areas of interest in Hilbert spectra between 10E-1 Hz and 1 Hz, corresponding with the occurrence of transients in the respective ECN signals. Regarding the detection of MIC, together with monitoring of the OCP and microscopic observations, the development of ECN transients generated by localized corrosion processes could be attributed to the presence and activity of sulphate-reducing bacteria. These transients are related to the existence of pits in the carbon steel surface, underneath the attached biofilm. Finally, practical aspects and configurations for electrochemical noise measurements (ENM) are discussed. ENM can be applied in a hand-held solution, or for permanent monitoring. Analogous to the selection of the appropriate data analysis procedure to obtain the information of interest, it is important to consider the required application to select the most suitable configuration. ENM is a potentially interesting technique because of its non-intrusive nature, the robust sensor configurations, the ability to identify localized corrosion processes and ease of use. The most complicated aspect of ENM is the interpretation of the EN signals, for which the data analysis procedure can be fully automated if required.Materials Science & EngineeringMechanical, Maritime and Materials Engineerin