Computational fluid dynamics calculations of a spillway’s energy dissipation

To make sure that a dam is safe it is important to have good knowledge about the energy dissipation in the spillway. Physical hydraulic model tests are reliable when investigating how the water flow behaves on its way through the spillway. The problem with physical model testing is that it is both expensive and time consuming, therefore computational fluid dynamics, CFD, is a more feasible option. This projects focuses on a spillway located in Sweden that Vattenfall R&D built a physical model of to simulate the water discharge and evaluate the energy dissipation in order to rebuild the actual spillway. The main purpose of this project is to evaluate if the physical hydraulic test results can be reproduced by using CFD, and obtain detailed results about the flow that could not be obtained by physical testing. There are several steps that need to be completed to create a CFD-model. The first step is to create a geometry, then the geometry needs to be meshed. After the meshing the boundary conditions need to be set and the different models, multiphase model and the viscous model, need to be defined. Next step is to set the operating conditions and decide which solution method that will be used. Then the simulation can be run and the results can get extracted. In this project two CFD simulations were performed. The first simulation was to be compared with the physical hydraulic model test results and the second CFD simulation was of the rebuilt spillway. The results proved that the physical model test results could be recreated by using CFD. It also gave a better understanding of how the energy dissipation was in the spillway and indicates that the reconstruction of the actual spillway was successful since the new spillway both had a higher water discharge capacity and better energy dissipation