Investigation on hardening and softening behavior of steel after rapid strain rate changes

The design of industrial hot metal forming processes nowadays is mostly carried out using commercial Finite Element (FE) software codes. For precise FE simulations, reliable material properties are a crucial factor. In bulk metal forming, the most important material property is the materials flow stress, which determines the form filling and the necessary forming forces. At elevated temperatures, the flow stress of steels is determined by strain hardening, dynamic recovery and partly by dynamic recrystallization, which is dependent on strain rate and temperature. To simulate hot forming processes, which are often characterized by rapidly changing strain rates and temperatures, the flow stress is typically derived from flow curves, determined at arbitrary constant temperatures and strain rates only via linear interpolation. Hence, the materials instant reaction and relaxation behavior caused by rapid strain rate changes is not captured during simulation. To investigate the relevance of the relaxation behavior for FE simulations, trails with abrupt strain rate change are laid out and the effect on the material flow stress is analyzed in this paper. Additionally, the microstructure evolution due to the strain rate change is investigated. For this purpose, cylinder compression tests of an industrial case hardening steel are conducted at elevated temperatures and different strain rates. To analyze the influence of rapid strain rate changes, changes by one power of ten are performed at a strain of 0.3. As a reference, flow curves of the same material are determined at the initial and final constant strain rate. To investigate the microstructure evolution, compression samples are quenched at different stages, before and after the strain rate change. The results show that the flow curves after the strain rate change tend to approximate the flow curves measured for the final strain rate. However, directly after the strain rate change significant differences between the assumed instant flow stress and the real material behavior can be observed. Furthermore, it can be shown that the state of dynamic recrystallization at the time of the strain rate change influences the material response and relaxation behavior resulting in different slopes of the investigated flow curves after the strain rate change