Add to ORKGHere the results of modification of structure of materials at pulsed plasma processing on CPA-30 accel-erator are presented. The changes of physical-mechanical properties by reason of structure and phase transformation in material at difference plasma parameters impact are observed. When you are citing the document, use the following link http://essuir.sumdu.edu.ua/handle/123456789/3638
The paper considers the results of an electron microscopy study of the VD1 alloy of the Al-Cu-Mg sys...
Abstract – The possibility to form nanostructured surface layers on samples by their cladding with r...
We investigate the effect of pulse flows of hydrogen, helium, and hydrogen-helium plasma of a specif...
Copyright © 2013 Anuar Zhukeshov et al. This is an open access article distributed under the Creativ...
Surface modifications and features of materials alloying under pulsed plasma exposures are investiga...
The work is devoted to the structural-phase analysis of steels of the austenitic and martensitic gra...
© Published under licence by IOP Publishing Ltd.The change features of surface steel layer were inve...
The structure, phase composition and hardness of a 20X13 steel coating treated with two consecutive ...
The structure, size and hardness of the zone of hardening of pre-annealed steels (30XHMA, 34XH1M, 35...
In this study, microstructure and surface properties of low carbon steels (St52) treated by pulse pl...
The pulse plasma system is a surface modification method applied to steel samples. In the present st...
© Published under licence by IOP Publishing Ltd.The influence of conditions of plasma surface treatm...
Structural-phase transformations in 0.34C–1Cr–1Ni–1Mo–Fe steel during plasma electrolytic hardening ...
A comparative analysis of the microstructure and durability of hard-alloy plates treated with high-e...
Pulsed plasma treatment was applied for surface modification and laminated coating deposition on 14....
The paper considers the results of an electron microscopy study of the VD1 alloy of the Al-Cu-Mg sys...
Abstract – The possibility to form nanostructured surface layers on samples by their cladding with r...
We investigate the effect of pulse flows of hydrogen, helium, and hydrogen-helium plasma of a specif...
Copyright © 2013 Anuar Zhukeshov et al. This is an open access article distributed under the Creativ...
Surface modifications and features of materials alloying under pulsed plasma exposures are investiga...
The work is devoted to the structural-phase analysis of steels of the austenitic and martensitic gra...
© Published under licence by IOP Publishing Ltd.The change features of surface steel layer were inve...
The structure, phase composition and hardness of a 20X13 steel coating treated with two consecutive ...
The structure, size and hardness of the zone of hardening of pre-annealed steels (30XHMA, 34XH1M, 35...
In this study, microstructure and surface properties of low carbon steels (St52) treated by pulse pl...
The pulse plasma system is a surface modification method applied to steel samples. In the present st...
© Published under licence by IOP Publishing Ltd.The influence of conditions of plasma surface treatm...
Structural-phase transformations in 0.34C–1Cr–1Ni–1Mo–Fe steel during plasma electrolytic hardening ...
A comparative analysis of the microstructure and durability of hard-alloy plates treated with high-e...
Pulsed plasma treatment was applied for surface modification and laminated coating deposition on 14....
The paper considers the results of an electron microscopy study of the VD1 alloy of the Al-Cu-Mg sys...
Abstract – The possibility to form nanostructured surface layers on samples by their cladding with r...
We investigate the effect of pulse flows of hydrogen, helium, and hydrogen-helium plasma of a specif...