Cavitating propeller flows predicted by RANS solver with structured grid and small reynolds number turbulence model approach

Within the EU research project VIRTUE, a propeller is investigated in uniform and nonuniform inflow conditions by means of a RANS equation solver, FINFLO. The analyses are made in wetted and cavitating conditions. The propeller analyzed in this paper is the INSEAN E779A propeller. The paper contains calculations at three different grid resolutions in wetted conditions and at the two finest grid resolutions in cavitating conditions in uniform inflow. The mediumsize grid is used for the propeller in nonuniform inflow simulations. The simulations are conducted on a model scale and the results are compared with the measurements and cavitation tests performed by INSEAN. The nonuniform inflow is generated by modeling the geometry of the artificial wake generator used in the cavitation tests in the calculation domain. The experimental results are published in several papers, for example in [1] and [2]. The predicted propeller open water thrust and torque are found to be within 5 % of the measured ones. The pressure peak at the leading edge of a blade is found to be sensitive to the grid resolution. The predicted cavitation behavior of the propeller blades is in reasonable accordance with the cavitation test observations. In uniform inflow the vaporized region is overpredicted. Contrastingly, the vaporized region is Underpredicted in the nonuniform inflow calculations. Side entrant jets could be identified in the cavity region in the nonuniform inflow simulations. The predicted vaporized regions in several blade positions together with photographs of the cavitating propeller are shown for comparison. The cavitation behavior trends seemed to be similar in the simulations and observations in nonuniform inflow, except that the rollup of detached sheet cavitation into a tip vortex could not be captured in the calculations. The total wake is measured between the propeller plane and the wake generator. The predicted wake is found to be too strong, but the width of the wake is relatively close to the measurements. The propeller loading history is shown over one propeller revolution. It shows qualitatively reasonable trends. The loading histories of the wetted and cavitating propeller are almost the same due to the relative small cavitating region in the investigated conditions. The pressure distributions at several blade positions on the suction side of the propeller are shown in wetted and cavitating conditions for comparison.http://deepblue.lib.umich.edu/bitstream/2027.42/84244/1/CAV2009-final45.pd