Innovative low temperature regenerable zinc based mixed oxide sorbents for synthesis gas desulfurization

International audienceZinc oxide-based materials are commonly used for the final desulfurization of synthesis gas in IGCC and Fischer-Tropsch based XTL processes. The formation of large amount of solid waste is the major issue of this process. In-situ oxidative regeneration is a promising way to reduce this waste formation and enhance desulfurization process efficiency and economics. However, previous studies showed that one of the major drawbacks of oxidative regeneration of sulfided oxides relies in the high operating temperature range required to overcome the formation of inhibitory sulfate phases. A preliminary work of the authors focused on single oxides identified that regeneration temperature of zinc oxide-based sorbent could be reduced through the addition of molybdenum oxide. Two composites oxides -a single oxides mixture (ZnO and MoO 3) and a mixed oxide (ZnMoO 4) -were synthesized and characterized. Their sulfidation and oxidative regeneration properties were investigated through thermogravimetry and in-situ characterizations. Sulfidation of the single oxides mixture was shown to be similar to the combination of the sulfidation of both independent single oxides. Mixed oxide sulfidation leads to ZnMoO 4 phase demixing into ZnS, MoS 2 and ZnMoO 3 . The oxidative regenerations of the sulfided single oxide mixtures and mixed oxide are initiated, respectively, at 350°C and 300°C. These temperatures are 250°C and 300°C lower than the regeneration temperature of a pure ZnS. For the sulfided mixed oxide regeneration is even complete a