Cratonization and thermal evolution of the mantle

The stabilization of continental lithosphere to form cratons is accomplished by volatile loss from the upper mantle during magmatic events associated with the formation of continental crust. Volatile depletion elevates the solidus and increases the stiffness of the mantle residuum, thereby imparting a resistance to subsequent melting and deformation. Freeboard is maintained in part by the buoyancy associated with an increased Mg/(Mg + Fe) ratio in the mantle residuum following extraction of crustal material. Augmented subcratonic seismic velocities derive from the same shift in this ratio. The higher effective viscosity of the stabilized subcratonic upper mantle inhibits its entrainment in mantle convection, and locally thickens the conductive boundary layer. Heat approaching from greater depths is diverted away from the stiff craton to other areas that continue to transfer heat by convection, thus yielding a low surface heat flow within cratons.Cratonization by devolatilization and petrologic depletion was most effective in the Archean and has diminished in effectiveness over geologic time as the mantle temperature has fallen because of the declining store of internal heat. From the Archean to the present that ascending mantle material which has undergone partial melting has encountered the solidus at progressively shallower depth, has remained supersolidus over a smaller depth range, has temperatures which have exceeded the solidus by lesser amounts, has undergone diminishing degrees of partial melting, and has experienced less thorough devolatilization. At a given time the rate of production of continental crust is likely to be proportional to the depth extent and fraction of partial melting. Integration of the partial melt zone over time yields a growth curve that is similar to some continental crustal growth curves inferred from isotopic evolution.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/26023/1/0000095.pd