Finite element simulation of plates under non-uniform blast loads using a point-load method: Buried explosives

There are two primary challenges associated with assessing the adequacy of a protective structure to resist explosive events: firstly the spatial variation of load acting on a target must be predicted to a sufficient level of accuracy; secondly, the response of the target to this load must also be quantified. When a high explosive is shallowly buried in soil, the added confinement given by the geotechnical material results in a blast which is predominantly directed vertically. This imparts an extremely high magnitude, spatially non-uniform load on the target structure. A recently commissioned experimental rig designed by the authors has enabled direct measurements of the blast load resulting from buried explosive events. These direct measurements have been processed using an in-house interpolation routine which evaluates the load acting over a regular grid of points. These loads can then be applied as the nodal-point loads in a finite element model. This paper presents results from a series of experiments where a free-flying plate was suspended above a shallow buried explosive. Dynamic and residual deformations are compared with finite element simulations of plates using the experimentally recorded, and interpolated, nodal point-loads. The results show very good agreement and highlight the use of this method for evaluating the efficacy of targets subjected to non-uniform blast loads