The electrochemical response of melt-spun Al-Ni-La alloys with partial substitution of Ni after different stages of devitrification was studied. The base alloy was found to have the best corrosion resistance. It was observed that primary crystallization caused minimal deterioration in the corrosion resistance of the base alloy as compared to its amorphous state. The substitute alloys had different corrosion resistance dependent on the substituting element with the Ag containing alloy having the least resistance. This could be attributed to the operation of local galvanic cells, enhanced by chemical heterogeneities in the alloys. Secondary crystallization caused a reduction in the corrosion resistance of all the alloys due to the creation of...
The electrochemical behavior of Al-Mg alloys were studied by means of a potentiostat. Since oxide fi...
The corrosion behaviour of innovative Li-containing (AA2198) and Ag-containing (AA2139) aluminium a...
The corrosion resistance of passive layers was studied on cast Al-Ni alloys with an ever-increasing ...
The electrochemical response of Al94−xNi6Lax alloys (x = 4, 5, 6, 7) after different stages of devit...
Two amorphous ribbons with the compositions of Al88Ni6La6 and Al86Ni6La6Cu2 were made using the melt...
In this study, the corrosion mechanisms of the AA2024-T3 and the AA2098-T351 were investigated and c...
Microstructural control through heat treatments is one of the most important means of designing allo...
Electrochemical measurements and microstructural studies were carried out to investigate the corrosi...
An investigation about the corrosion resistance of Ni-Al-Cu intermetallic alloys in simulated human ...
The effect of varying the percent crystallinity on the electrochemical behavior of Mg65Cu25Y10 and M...
Ni-P alloys were prepared by electrodeposition u der different conditions on a r(itating disk electr...
International audienceA comparison of the corrosion behaviour of simplified chromia- and alumina-for...
The effect of thermally-induced surface segregation on the electrochemical corrosion behavior of Al-...
The influence of annealing treatment on the microstructure and the corrosion behaviour of a complex ...
The effect of Ni as a minor alloying element on the anodic dissolution behavior of solute rich Al-Cu...
The electrochemical behavior of Al-Mg alloys were studied by means of a potentiostat. Since oxide fi...
The corrosion behaviour of innovative Li-containing (AA2198) and Ag-containing (AA2139) aluminium a...
The corrosion resistance of passive layers was studied on cast Al-Ni alloys with an ever-increasing ...
The electrochemical response of Al94−xNi6Lax alloys (x = 4, 5, 6, 7) after different stages of devit...
Two amorphous ribbons with the compositions of Al88Ni6La6 and Al86Ni6La6Cu2 were made using the melt...
In this study, the corrosion mechanisms of the AA2024-T3 and the AA2098-T351 were investigated and c...
Microstructural control through heat treatments is one of the most important means of designing allo...
Electrochemical measurements and microstructural studies were carried out to investigate the corrosi...
An investigation about the corrosion resistance of Ni-Al-Cu intermetallic alloys in simulated human ...
The effect of varying the percent crystallinity on the electrochemical behavior of Mg65Cu25Y10 and M...
Ni-P alloys were prepared by electrodeposition u der different conditions on a r(itating disk electr...
International audienceA comparison of the corrosion behaviour of simplified chromia- and alumina-for...
The effect of thermally-induced surface segregation on the electrochemical corrosion behavior of Al-...
The influence of annealing treatment on the microstructure and the corrosion behaviour of a complex ...
The effect of Ni as a minor alloying element on the anodic dissolution behavior of solute rich Al-Cu...
The electrochemical behavior of Al-Mg alloys were studied by means of a potentiostat. Since oxide fi...
The corrosion behaviour of innovative Li-containing (AA2198) and Ag-containing (AA2139) aluminium a...
The corrosion resistance of passive layers was studied on cast Al-Ni alloys with an ever-increasing ...