The consideration of compliance of structural joints in calculation of large panel buildings

The article presents and analyzes the design solutions of horizontal and vertical joints, as well as methods for determining the coefficient of compliance joints. It also presents the numerical determination of the coefficients of compliance of the horizontal mortar joint in accordance with the standards for the design of large-panel buildings. It is shown that the compliance of the joint on the embedded parts consists of the compliance of the connecting element, embedded parts of the wall panels, namely the metal plate and reinforcing bars of the anchors, as well as the compliance of the welds. In this case, the joint operates in a complex stress-strain state. It is noted that the most difficult is to determine the compliance of embedded parts. Three calculation methods have been developed for the numerical determination of the compliance coefficients of anchor bars under the action of tension (compression), bending moment and shear forces on the embedded part. The deformation of the welds was defined in MGSU in the framework of the experimental research of the work of the vertical seam with embedded parts. The article presents a graph of the deformation in the weld on the applied vertical load on the test piece