Features of optimization of model parameters for solving geotechnical problems

At present, numerical methods of calculations, which are implemented in a large number of software complexes, are widely used in geotechnical practice and the definition of input parameters of the ground is very important and necessary to reflect the real work of the foundation of geotechnical structures [1-4]. There are often cases when the results obtained during laboratory tests of soils are not accepted by software complexes, errors are given, recommendations are proposed for changing the parameters in the direction of increasing or decreasing. In connection with these problems, the question arose about the need to optimize soil parameters obtained as a result of laboratory tests to compare and correct these parameters, based on the degree of approximation of model tests with laboratory tests [5]. Optimization of soil parameters can be carried out in the subroutine Soil test, incorporated in the PLAXIS geotechnical software [6]. Using the Soil test, the triaxial and compression tests are simulated based on the input parameters of the soil and the initial test data. The purpose of this study was to describe the methodology for optimizing the parameters of the Hardening Soil model and the Soft Soil Creep model using the PLAXIS 3D software geotechnical complex, as well as a comparative analysis of the results of laboratory soil tests with modeling results in software complex