In this paper, some of the results of dielectric study carried out using locally produced low cost Fe2O3 powder with 0.5 wt% of Si additive are being summarized. The dielectric properties were studied as a function of composition, frequency and temperature for a series of MnxZn1-xFe2O4 ferrite. The samples were prepared by the usual ceramic technique. It was observed that the values obtained for dielectric constant ∈′ and dielectric loss factor tan δ are much lower than those normally obtained for Mn-Zn ferrite prepared by pure Fe2O3 powder. The low values are attributed to the presence of Si, which suppress the ceramic grain growth. The low dielectric loss makes these samples attractive for use at high frequencies. Each of ∈′ and tan δ inc...
Mn-Zn ferrite ceramics were prepared through usual ceramic method using different iron oxide raw mat...
Starting hematite (Fe2O3), zinc oxide (ZnO) and manganese carbonate (MnCO3) powders were homogenized...
Starting hematite (Fe2O3), zinc oxide (ZnO) and manganese carbonate (MnCO3) powders were homogenized...
In this paper, some of the results of dielectric study carried out using locally produced low cost F...
Abstract. Dielectric properties such as dielectric constant (e¢) and dielectric loss tangent (tan d)...
The dielectric constant of Mn-Zn ferrite was measured at different temperature and frequencies as a ...
Ferrites have widely been used in different electrical engineering applications including radio and ...
Recently, the operating frequency of switching mode power supplies has been increased from 25 kHz to...
Recently, the operating frequency of switching mode power supplies has been increased from 25 kHz to...
Many physicists have studied the electrical and magnetic properties of polycrystalline ferrites in v...
The temperature and frequency dependence of dielectric permittivity and dielectric loss of nanosized...
The tenacity of the present study was to develop a material using an economical chemical route, havi...
The temperature and frequency dependence of dielectric permittivity and dielectric loss of nanosized...
Spinel Mn-Zn ferrites with composition MnxZn0.4Ca0.6-2xFe2+xO4,where x = 0.10, 0.15, 0.20, 0.25 and ...
Mn-Zn ferrite ceramics were prepared through usual ceramic method using different iron oxide raw mat...
Mn-Zn ferrite ceramics were prepared through usual ceramic method using different iron oxide raw mat...
Starting hematite (Fe2O3), zinc oxide (ZnO) and manganese carbonate (MnCO3) powders were homogenized...
Starting hematite (Fe2O3), zinc oxide (ZnO) and manganese carbonate (MnCO3) powders were homogenized...
In this paper, some of the results of dielectric study carried out using locally produced low cost F...
Abstract. Dielectric properties such as dielectric constant (e¢) and dielectric loss tangent (tan d)...
The dielectric constant of Mn-Zn ferrite was measured at different temperature and frequencies as a ...
Ferrites have widely been used in different electrical engineering applications including radio and ...
Recently, the operating frequency of switching mode power supplies has been increased from 25 kHz to...
Recently, the operating frequency of switching mode power supplies has been increased from 25 kHz to...
Many physicists have studied the electrical and magnetic properties of polycrystalline ferrites in v...
The temperature and frequency dependence of dielectric permittivity and dielectric loss of nanosized...
The tenacity of the present study was to develop a material using an economical chemical route, havi...
The temperature and frequency dependence of dielectric permittivity and dielectric loss of nanosized...
Spinel Mn-Zn ferrites with composition MnxZn0.4Ca0.6-2xFe2+xO4,where x = 0.10, 0.15, 0.20, 0.25 and ...
Mn-Zn ferrite ceramics were prepared through usual ceramic method using different iron oxide raw mat...
Mn-Zn ferrite ceramics were prepared through usual ceramic method using different iron oxide raw mat...
Starting hematite (Fe2O3), zinc oxide (ZnO) and manganese carbonate (MnCO3) powders were homogenized...
Starting hematite (Fe2O3), zinc oxide (ZnO) and manganese carbonate (MnCO3) powders were homogenized...