Emulsifying Properties Of Collagen Fibers: Effect Of Ph, Protein Concentration And Homogenization Pressure

The emulsifying properties of collagen fibers were evaluated in oil-in-water (O/W) emulsions produced under different conditions of pH, protein content and type of emulsification device (rotor-stator and high-pressure homogenizer). The stability, microstructure and rheology of the O/W emulsions were measured. The phase separation and droplet size of the emulsions prepared using the rotor-stator device (primary emulsion) decreased with protein concentration and reduction in pH, allowing the production of electrostatically stable emulsions at pH 3.5. In contrast, emulsions at higher pH values (4.5, 5.5 and 7.5) showed a microscopic three-dimensional network responsible for their stability at protein contents higher than 1.0% (w/w). The emulsions at pH 3.5 homogenized by high pressure (up to 100MPa) showed a decrease in surface mean diameter (d32) with increasing pressure and the number of passes through the homogenizer. These emulsions showed droplets with lower dispersion and d32 between 1.00 and 4.05μm, six times lower than values observed for primary emulsions. The emulsions presented shear-thinning behavior and lower consistency index and viscosity at higher homogenization pressures. In addition, the emulsions showed a less structured gel-like behavior with increase in homogenization pressure and number of passes, since the pressure disrupted the collagen fiber structure and the oil droplets. The results of this work showed that the collagen fiber has a good potential for use as an emulsifier in the food industry, mainly in acid products. © 2010 Elsevier Ltd.254604612Ambrosone, A., Ceglie, A., A novel approach for determining the droplet size distribution in emulsion systems by generating function (1997) Journal of Chemical Physics, 24, pp. 10756-10763Anton, N., Benoit, J., Saulnier, P., Design and production of nanoparticles formulated from nano-emulsion templates - a review (2008) Journal of Controlled Release, 128, pp. 185-199Asghar, A., Henrickson, R.L., Chemical, biochemical, functional, and nutritional characteristics as collagen in food systems (1982) Advances in Food Research, 28, pp. 231-372Chen, J., Dickinson, E., Edwards, M., Rheology of acid-induced sodium caseinate stabilized emulsion gels (1999) Journal of Texture Studies, 30, pp. 377-396Chhabra, R.P., Agarwal, S., Chaudhary, K., A note on wall effect on the terminal falling velocity of a sphere in quiescent Newtonian media in cylindrical tubes (2003) Powder Technology, 19, pp. 53-58Cortés-Muñoz, M., Chevalier-Lucia, D., Dumay, E., Characteristics of submicron emulsions prepared by ultra-high-pressure homogenization: effect of chilled or frozen storage (2009) Food Hydrocolloids, 23, pp. 640-654Coupland, J.N., McClements, D.J., Droplet size distribution on food emulsions: comparison of ultrasonic and light scattering methods (2001) Journal of Food Engineering, 50, pp. 117-120Desrumaux, A., Marcand, J., Formation of sunflower oil emulsions stabilized by whey proteins with high-pressure homogenization (up to 350MPa): effect of pressure on emulsion characteristics (2002) International Journal of Food Science and Technology, 37, pp. 263-269Dickinson, E., (1992) An introduction to food hydrocolloids, , Oxford University Press, Oxford, UKFloury, J., Belletre, J., Legrand, J., Desrumaux, A., Analysis of a new type of high-pressure homogenizer. A study of the flow pattern (2004) Chemical Engineering Science, 59, pp. 843-853Floury, J., Desrumaux, A., Axelos, M.A.V., Legrand, J., Effect of high-pressure homogenization on methylcellulose as food emulsifier (2003) Journal of Food Engineering, 58, pp. 227-238Floury, J., Desrumaux, A., Lardières, J., Effect of high-pressure homogenization on droplet size distributions and rheological properties of model oil-in-water emulsions (2000) Innovative Food Science & Emerging Technologies, 1, pp. 127-134Freudig, B., Tesch, S., Schubert, H., Production of emulsions in high-pressure homogenizer - part II: influence of cavitation on droplet breakup (2003) Engineering Life Science, 3, pp. 266-270Garti, N., What can nature offer from an emulsifier point of view: trends and progress? (1999) Colloids and Surfaces A: Physicochemical and Engineering Aspects, 152, pp. 125-146Innocente, N., Biasutti, M., Venir, E., Spaziani, M., Marchesini, G., Effect of high-pressure homogenization on droplet size distribution and rheological properties of ice cream mixes (2009) Journal of Dairy Science, 92, pp. 1864-1875Jafari, S.M., Assadpoor, E., He, Y., Bhandari, B., Re-coalescence of emulsion droplets during high-energy emulsification (2008) Food Hydrocolloids, 22, pp. 1191-1202Keerati-u-rai, M., Corredig, M., Heat-induced changes in oil-in-water emulsions stabilized with soy protein isolate (2009) Food Hydrocolloids, 23, pp. 2141-2148Keowmaneechai, E., McClements, D.J., Influence of EDTA and citrate on physicochemical properties of whey protein-stabilized oil-in-water emulsions containing CaCl2 (2002) Journal of Agricultural and Food Chemistry, 50, pp. 7145-7153Krog, N.J., Sparso, F.V., Food emulsifiers: their chemical and physical properties (2004) Food emulsions, p. 141. , Marcel Dekker, New York, S.E. Friberg, K. Larsson, J. Sjoblom (Eds.)Lizarraga, M.S., Pan, L.G., Añon, M.C., Santiago, L.G., Stability of concentrated emulsions measured by optical and rheological methods. Effect of processing conditions - I. Whey protein concentrate (2007) Food Hydrocolloids, 22, pp. 868-878Marie, P., Perrier-Cornet, J.M., Gervais, P., Influence of major parameters in emulsification mechanisms using a high-pressure jet (2002) Journal of Food Engineering, 53, pp. 43-51Máximo, G.J., Cunha, R.L., (2008), p. 70. , Physical properties of collagen derivatives for food applications. In V Jornada Internacional de Proteínas e Colóides Alimentares. Ital, Campinas-SPMcClements, D.J., (2005) Food emulsions: Principles, practice, and techniques, , CRC Press, WashingtonMcClements, D.J., Coupland, J.N., Theory of droplet size distribution measurements en emulsions using ultrasonic spectroscopy (1996) Colloids and Surfaces A, 117, pp. 161-170Mohan, S., Narsimhan, G., Coalescence of protein-stabilized emulsions in a high-pressure homogenizer (1997) Journal of Colloid and Interface Science, 192, pp. 1-15Neirynck, N., Van lent, K., Dewettinck, K., Van der Meeren, P., Influence of pH and biopolymer ratio on sodium caseinate-guar gum interactions in aqueous solution and in O/W emulsion (2007) Food Hydrocolloids, 21, pp. 862-869Neklyudov, A.D., Nutritive fibers of animal origin: collagen and its fractions as essential components of new and useful food products (2003) Applied Biochemistry and Microbiology, 39, pp. 229-238Nicoleti, J.F., Telis, V.R.N., Viscoelastic and thermal properties of collagen-xanthan gum and collagen-maltodextrin suspensions during heating and cooling (2009) Food Biophysics, 4, pp. 135-146Olivo, R., Shimokomaki, M., (2002) Carnes: No caminho da Pesquisa, , Imprint, Cocal do SulPal, R., Shear viscosity behaviour of emulsions of two immiscible liquids (2000) Journal of Colloid and Interface Science, 225, pp. 359-366Perrechil, F.A., Cunha, R.L., Oil-in-water emulsions stabilized by sodium caseinate: influence of pH, high-pressure homogenization and locust bean gum addition (2010) Journal of Food Engineering, 97, pp. 441-448Pugnaloni, L.A., Matia-Merino, L., Dickinson, E., Microstructure of acid induced caseinate gels containing sucrose: quantification from confocal microscopy and image analysis (2005) Colloid Surface B, 42, pp. 211-217Sandra, S., Dalgleish, D.G., Effects of ultra-high-pressure homogenization and heating on structural properties of casein micelles in reconstituted skim milk powder (2005) International Dairy Journal, 15, pp. 1095-1104Schimidt, K.A., Smith, D.E., Effects of varying homogenization pressure on the physical properties of vanilla ice cream (1989) Journal of Dairy Science, 72, pp. 378-384Schulz, M.B., Daniel, R., Hydroxypropylmethylcellulose (HPMC) as emulsifier for submicron emulsions: influence of molecular weight and substitution type on the droplet size after high-pressure homogenization (2000) European Journal of Pharmaceutics and Biopharmaceutics, 49, pp. 231-236Surh, J., Deckes, E.A., McClements, J., Properties and stability of oil-in-water emulsion stabilized by fish gelatin (2006) Food Hydrocolloids, 20, pp. 596-606Usha, R., Ramasami, T., The effects of urea and n-propanol on collagen denaturation: using DSC, circular dicroism and viscosity (2004) Thermochimica Acta, 409, pp. 201-206Walstra, P., Smulders, I., Making emulsions and foams: an overview (1997) Food colloids: Proteins, lipids and polysaccharides, pp. 367-381. , The Royal Society of Chemistry, Cambridge, UK, E. Dickinson, B. Bergenstahl (Eds.)Wolf, K.L., Sobral, P.J.A., Telis, V.R.N., Physicochemical characterization of collagen fibres and collagen powder for selfcomposite film production (2009) Food Hydrocolloids, 23, pp. 1886-189