Synthesis, structural, magnetic and electrochemical properties of LiNi1/3Mn1/3Co1/3O2 prepared by a sol–gel method using table sugar as chelating agent

Table sugar (sucrose) was used as a new and cheap chelating agent to prepare LiNi1/3Mn1/3Co1/3O2. X-ray diffraction (XRD) shows that the powder adopts the α-NaFeO2 layered structure with space group View the MathML source. The high value of c/a above 4.97 indicates a well-ordered rhombohedral lattice. The refined degree of cationic mixing of 2.4% remains fixed upon cycling. The fatigue of the material used as a positive electrode of a Li-cell has been investigated by scanning and transmission electron microscopy (SEM and TEM) as well as the magnetic measurements in the initial, charged and discharged state at low C/10 rate over the 10th first cycles. Small cracks are observed after cycling, despite the low C-rate and the voltage range limited to 3.0–4.2 V in which only the Ni is electrochemically active. This fatigue, however, has no sizeable impact on the capacity: the initial capacity ≈150 mAh g−1 was retained at the 10th cycle (ca. 97%)