Assessment of viscosity calculation for calcium-silicate based slags using computational thermodynamics

This study focuses on the viscosity calculation of molten slags using computational thermodynamics. Different slag systems and their measured viscosities from different references were used and compared with those obtained through FactSage software. To calculate the viscosity of each slag the Viscosity module available in Fact- Sage 6.4 was used. In order to perform the evaluation of computational thermodynamics in viscosity calculation, six different slag systems were presented, all of which were formed of calcium-silicate melts. In total, 162 slags, in temperatures ranges from 1423 K (1150 ºC) to 2089 K (1816 °C) were presented for all slag systems. The software showed a tendency to produce viscosity values lower than those found in the literature measured by an experimental method. The relative deviation between the measured and calculated viscosity values is in the range of 13.31 to 37.53% for evaluated systems. Considering all references and systems, the average deviation between measured and calculated viscosities is 23.61%, which, according to literature, is an acceptable value. The CaO-SiO2-Al2O3 and CaO-SiO2-FeO systems showed the best agreement between the experimental method and the method calculated through FactSage 6.4 with a very good fitting between viscosity values