Drying characteristics of biosludge from pulp and paper mills

Handling and disposal of biosludge has been a persistent problem for many pulp and paper mills primarily because of the material’s high moisture content and poor dewatering and drying characteristics. Most biosludge is landfilled or incinerated, and some is used as a soil amendment. To incinerate biosludge, the mills mix it with primary sludge, mechanically dewater the mixture to 15%–30% solids, and burn it with hog fuel in biomass boilers. For biosludge to burn effectively, however, it must be dewatered or dried to at least 30%–35% solids. A sys - tematic study was conducted to examine the drying characteristics of biosludge collected from pulp and paper mills at various temperatures using a thermogravimetric dryer. The drying behavior of the tested biosludges was similar, adding fillers such as wood fines and biomass boiler fly ash to biosludge up to 30 wt% did not significantly affect the drying rate, higher organic content might make biosludge more difficult to dry, and increasing drying tempera - ture significantly increases the drying rate as expected.This work was conducted as part of the research program Increasing Energy and Chemical Recovery Efficiency in the Kraft Process—III. The program is jointly supported by the Natural Sciences and Engineering Research Council of Can - ada (NSERC) and a consortium of the following companies: Andritz, AV Nackawic, Babcock & Wilcox, Boise, Carter Holt Harvey, Celulose Nipo-Brasileira, Clyde-Bergemann, DMI Peace River Pulp, Eldorado, ERCO Worldwide, Fibria, FPIn - novations, International Paper, Irving Pulp & Paper, Kiln Flame Systems, Klabin, StoraEnso Research, Suzano, Tembec, Tolko Industries, Valmet, and WestRock