On the role of normal boundary condition in interface shear test for the determination of skin friction along pile shaft

This paper presents numerical results from a two-dimensional discrete element method (DEM) simulation study on the influence of lateral boundary condition on the shaft resistance of a pile driven into a crushable sand. The study was made by comparing the simulation results from the pile penetration test and the interface shear test employing parallel-bonded agglomerates for the modeling of particle breakage. The interface shear test was performed under three different types of normal boundary condition, namely, constant normal load (CNL), constant normal stiffness (CNS), and constant volume (CV) boundary conditions. For the pile penetration test, a series of sampling windows were identified on the initial ground configuration to monitor the stress-strain, volume change and particle breakage behavior of particle groups located within the sampling windows. A detailed investigation is then made by comparing the behavior of particle groups with that from the interface shear test to find out which type of the normal boundary condition best describes the lateral boundary condition in the pile penetration test. It is found that the behavior of a particle group has reached the peak state below the pile tip and the critical state after it reaches the pile shaft.The accepted manuscript in pdf format is listed with the files at the bottom of this page. The presentation of the authors' names and (or) special characters in the title of the manuscript may differ slightly between what is listed on this page and what is listed in the pdf file of the accepted manuscript; that in the pdf file of the accepted manuscript is what was submitted by the author