Transient and Steady-state Creep in a SnAgCu Lead-free Solder Alloy: Experiments and Modeling

It has been conventional to simplify the thermo-mechanical modeling of solder joints by omitting the primary (transient) contributions to total creep deformation, assuming that secondary (steady-state) creep strain is dominant and primary creep is negligible. The error associated with this assumption has been difficult to assess because it depends on the properties of the solder joint and the temperature-time profile. This research examines the relative contributions of primary and secondary creep in Sn3.8Ag0.7Cu solder using the constant load creep and stress relaxation measurements for bulk tensile specimens and the finite element analysis of a chip resistor (trilayer) solder joint structure that was thermally cycled under multiple temperature ranges and ramp rates. It was found that neglect of primary creep can result in errors in the predicted stress and strain of the solder joint. In turn, these discrepancies can lead to errors in the estimation of the solder thermal fatigue life due to the changing proportion of primary creep strain to total inelastic strain under different thermal profiles. The constant-load creep and stress relaxation data for Sn3.8Ag0.7Cu span a range of strain rates 10(-8) 1/s < strain rate < 10(-4) 1/s, and temperatures 25°C, 75°C and 100°C. Creep and stress relaxation measurements show that transient creep caused faster strain rates during stress relaxation for a given stress compared to the corresponding minimum creep rate from constant-load creep tests. The extent of strain hardening during primary creep was a function of temperature and strain rate. A constitutive creep model was presented for Sn3.8Ag0.7Cu that incorporates both transient and steady-state creep to provide agreement for both creep and stress relaxation data with a single set of eight coefficients. The model utilizes both temperature compensated time and strain rate to normalize minimum strain rate and saturated transient creep strain, thereby establishing equivalence between decreased temperature and increased strain rate. The apparent activation energy of steady-state creep was indicative of both dislocation core and bulk lattice diffusion was the most sensitive model parameter. A saturation threshold was defined that distinguishes whether primary or secondary creep is dominant under either static or variable loading.Ph