Stem modeling and simulation of conversion of cork oak stems for quality wood products

Recent research is underway to study cork oak (Quercus suber L.) wood potential for production of wood components. A total of 35 stems of young and mature cork oaks were sampled, live sawn into flitches, scanned using VTT’s WoodCIM®, and the measured data computed by VTT’s PuuPilot software, allowing stem 3D reconstruction. Sawing simulations were run for 0.5 m and 1 m logs and the whole stem. Sawn products were (1) planks, (2) parquet, (3) lamparquet, and (4) external component of multilayer planks. Cork oak stems showed a moderate to small taper (mean 24 mm/m). Curviness varied between straight to significantly crooked stems (mean value 40 mm) Batch yields for the tested products ranged 25–43% and 37–50% for 0.5 m logs of young and mature trees, respectively; for 1 m logs, batch yields ranged 19–41% and 25–54%. When using the whole stem, batch yields were lower, ranging 11–38% and 15–50%. Higher yields were obtained for all log lengths and samples for production of lamparquet, parquet, and multilayer component