A 16-SQUID array has been designed and fabricated, which shows 0.12 μΦ 0 Hz−1/2 flux noise at 4.2 K. The readout amplifier based on a cryogenic silicon-germanium bipolar transistor employs short-delay negative flux feedback and reaches 7 MHz bandwith for a 1 Φ 0p-p signal. The −1 dB compression is reached approximately at 4.2 Φ 0p-p amplitude when the signal frequency is 1 MHz. In the feedback mode the flux noise is anomalously increased to 0.35 μΦ 0 Hz−1/2
Digital Frequency-Domain Multiplexing (DfMux) is a technique that uses MHz superconducting resonator...
We present an ultra-low-noise instrumentation based on a standard BiCMOS SiGe 0.35 μm ASIC operating...
International audienceThis paper presents an ultra low noise instrumentation based on a standard BiC...
A 16-SQUID array has been designed and fabricated, which shows 0.12 µΦ0 Hz-1/2 flux noise at 4.2K. T...
We have constructed a two-stage SQUID amplifier intended for multiplexed cryogenic detector arrays. ...
A low-noise SQUID readout electronics with a high slew rate and an automatic gain control feature ha...
We have measured characteristics and noise of four commercially available SiGe heterojunction bipola...
I have experimented with a SiGe heterojunction transistor at 4.2 K acting as a readout amplifier for...
We have built a room temperature amplifier based on Si JFETs (junction field effect transistors) int...
We have constructed a two-stage SQUID amplifier, in which series-mixing local feedback has been used...
Local negative feedback derived within the cryogenic stage from the output current of a voltage-bias...
We have developed a set of dc SQUIDs intended for frequency-domain multiplexed readout of transition...
Digital Frequency-Domain Multiplexing (DfMux) is a technique that uses MHz superconducting resonator...
We present an ultra-low-noise instrumentation based on a standard BiCMOS SiGe 0.35 μm ASIC operating...
International audienceThis paper presents an ultra low noise instrumentation based on a standard BiC...
A 16-SQUID array has been designed and fabricated, which shows 0.12 µΦ0 Hz-1/2 flux noise at 4.2K. T...
We have constructed a two-stage SQUID amplifier intended for multiplexed cryogenic detector arrays. ...
A low-noise SQUID readout electronics with a high slew rate and an automatic gain control feature ha...
We have measured characteristics and noise of four commercially available SiGe heterojunction bipola...
I have experimented with a SiGe heterojunction transistor at 4.2 K acting as a readout amplifier for...
We have built a room temperature amplifier based on Si JFETs (junction field effect transistors) int...
We have constructed a two-stage SQUID amplifier, in which series-mixing local feedback has been used...
Local negative feedback derived within the cryogenic stage from the output current of a voltage-bias...
We have developed a set of dc SQUIDs intended for frequency-domain multiplexed readout of transition...
Digital Frequency-Domain Multiplexing (DfMux) is a technique that uses MHz superconducting resonator...
We present an ultra-low-noise instrumentation based on a standard BiCMOS SiGe 0.35 μm ASIC operating...
International audienceThis paper presents an ultra low noise instrumentation based on a standard BiC...