Combines on-water sail pressure and shape measurements to determine forces International collaboration involving researchers in France and New Zealand First published results of such measurements on asymmetric spinnakers Accuracy of the shape predictions from the highly curved sails is shown to be good Results give fine details of the pressure distributions along the height and chord Full-scale results from measurements on both a Stewart 34 and a J80An innovative method combining simultaneous on-water pressure and sail shape measurements for determining aerodynamic forces produced by sails is described and used on Stewart 34 and J80 Class yachts flying asymmetric spinnakers. Data were recorded in light and medium winds in order to chec...
This work presents a full-scale experimental study of a yacht rig and sails in real upwind sailing c...
A commercial code (ANSYS CFX10) which is based upon Reynolds Average Navier Stokes, is used here to ...
While historically sailmaking and saildesign were considered as arts, in the 20th century, mainly fr...
An innovative method combining simultaneous on-water pressure and sail shape measurements for determ...
This work presents a full-scale experimental study on a sailing yacht in downwind conditions with si...
This paper describes an experiment that was carried out in the Twisted Flow Wind Tunnel at The Unive...
Yacht downwind sails are complex to study due to their non-developable shape with high camber and ma...
While sailing offwind, the trimmer typically adjusts the downwind sail "on the verge of luffing", le...
A full-scale experimental study on an instrumented sailing yacht is conducted to better assess the a...
This work presents a wind tunnel experimental study on the effect of the leading edge flapping on th...
A novel method similar to marching technique was used to model wind tunnel tests. ► Sail trim criter...
The present work reports the first systematic results obtained in wind tunnel and at full scale with...
This paper sets out to investigate the vortex flow of spinnaker yacht sails, which are low-aspect-ra...
Over the past two decades, the numerical and experimental progresses made in the field of downwind s...
This work presents a full-scale experimental study of a yacht rig and sails in real upwind sailing c...
A commercial code (ANSYS CFX10) which is based upon Reynolds Average Navier Stokes, is used here to ...
While historically sailmaking and saildesign were considered as arts, in the 20th century, mainly fr...
An innovative method combining simultaneous on-water pressure and sail shape measurements for determ...
This work presents a full-scale experimental study on a sailing yacht in downwind conditions with si...
This paper describes an experiment that was carried out in the Twisted Flow Wind Tunnel at The Unive...
Yacht downwind sails are complex to study due to their non-developable shape with high camber and ma...
While sailing offwind, the trimmer typically adjusts the downwind sail "on the verge of luffing", le...
A full-scale experimental study on an instrumented sailing yacht is conducted to better assess the a...
This work presents a wind tunnel experimental study on the effect of the leading edge flapping on th...
A novel method similar to marching technique was used to model wind tunnel tests. ► Sail trim criter...
The present work reports the first systematic results obtained in wind tunnel and at full scale with...
This paper sets out to investigate the vortex flow of spinnaker yacht sails, which are low-aspect-ra...
Over the past two decades, the numerical and experimental progresses made in the field of downwind s...
This work presents a full-scale experimental study of a yacht rig and sails in real upwind sailing c...
A commercial code (ANSYS CFX10) which is based upon Reynolds Average Navier Stokes, is used here to ...
While historically sailmaking and saildesign were considered as arts, in the 20th century, mainly fr...