Evidence of multimodal vibration damping using a single piezoelectric patch with a negative capacitance shunt

International audienceIn this work, a piezoelectric patch shunted with a negative capacitance circuit has been used to simultaneously damp several modes of a square aluminum plate at low frequencies. The active nature of such electromechanical system leads to regions of instabilities in which the highest vibration attenuation performance appears in the softening region. Once the geometry is fixed, the system has two degrees of freedom, dominated by the electrical parameters of the circuit: the resistance and the negative capacitance. We tune both the value of the negative capacitance, in order to place the structure close to the instability in the softening region, and the resistance of the circuit in such that control the losses of the system. This work shows an optimal design to simultaneously damp several modes with non-zero electromechanical coupling factors using a single shunted patch at low frequencies. The problem is solved numerically and tested experimentally with good agreement. The results show the possibility of controlling the modal response of the system, opening prospects to improve the acoustic comfort with systems using piezoelectric shunted damping circuits with small additional mass with a high tunability by only adjusting the properties of the shunt