Alternativa bakkontakter för CZTS tunnfilmssolceller

In this thesis, alternative back contacts for Cu2ZnSnS4 (CZTS) thin film solar cells were investigated. Back contacts for two different configurations were studied, namely traditional single-junction cells with opaque back contacts and transparent back contacts for possible use in either tandem or bifacial solar cell configuration. CZTS is processed under chemically challenging conditions, such as high temperature and high chalcogen partial pressure. This places great demands on the back contact. Mo is the standard choice as back contact, but reacts with chalcogens to form MoS(e)2 while the CZTS decomposes, mainly into detrimental secondary phases. Thin MoS(e)2 is assumed to be beneficial for the electrical contact, but excessive thickness is detrimental to solar cell performance. The back contact acts as diffusion medium for Na during annealing when soda-lime glass is used as substrate. Na influences both defect passivation and doping in CZTS and increases the efficiency of the solar cells. The ability of the back contact to facilitate Na diffusion is an important property that must be monitored. Titanium nitride (TiN) as an interlayer between the opaque molybdenum (Mo) and CZTS as well as complete replacement of Mo with TiN back contacts were investigated. TiN was found to be chemically stable in typical anneal conditions. Formation of MoS(e)2 was observed only in areas where the TiN interlayers did not fully cover the Mo, following from the surface roughness of Mo and insufficient step-coverage of the sputter-deposition of TiN. Thick TiN interlayers (200 nm) were found to increase the diffusion of Na to the absorber layer from the glass substrate. For precursors annealed in sulfur atmosphere, improved device efficiency was observed for increased TiN thickness. Transparent back contacts can be used in either tandem configurations where two or more absorber materials are used to more efficiently use different parts of the solar spectra, or in bifacial solar cells to allow light to reach the absorber layer from two sides and thus increase the photocurrent. Thus far only a few studies have investigated transparent back contact materials in CZTS solar cell devices. Antimony-doped tin oxide (ATO) was studied as a transparent back contact for CZTS. Annealing of bare ATO resulted in complete reaction with S to form Sn–S compounds. When annealed below the CZTS, ATO was found to be stable at low temperature (<550 °C), and in some aspects even improved its properties. ATO back contacts resulted in significantly increased formation of Sn–S secondary phases on the CZTS absorber surface compared to the Mo reference. Sn–S secondary compounds on the absorber surface made it challenging to obtain good device performance. Adhesion and device behavior could be improved by pre-addition of NaF on the precursor prior to annealing