Creep behaviour at high temperature of a stabilized austenitic steel for Gen-IV nuclear power plants

International audienceASTRID is a fast-reactor prototype for the 4th generation of nuclear power plants. The material used for fuel cladding is a cold-worked austenitic stainless steel called AIM1. This grade was developed to limit irradiation-induced swelling and improve microstructural stability and mechanical properties in normal operating conditions. In case of incidental situations, the cladding might rapidly reach higher temperatures (700-950DC) where its stability might be affected. The microstructural and mechanical behaviour in this temperature range is experimentally addressed in this paper.Isothermal creep tests up to 1000DC under a wide range of stress levels enable to study viscoplastic flow, microstructural evolution under stress and damage/failure processes. In order to evaluate the effect of loading, microstructural characterizations (precipitation, recovery, and recrystallization states) on stress-free thermally-aged samples were also performed and compared with post-mortem examinations of creep specimens.Up to 750DC, AIM1 shows better creep strength than previous generations of 15-15Ti grades. Beyond 750DC, dislocation mobility increases which promotes recovery and recrystallization processes. As a consequence, competition between work hardening due to viscoplastic deformation and softening due to dynamic recovery takes place. At 950DC, viscoplastic flow is strongly affected by recrystallization during creep test, especially in the tertiary stage. Softening due to gradual recrystallization leads to longer tertiary stages and higher ductility during tests under lower stress levels (about 40 MPa applied stress). Ductile fracture predominates at any temperature.Characterizations on thin foils and carbon extractive replicas showed a large variety of precipitates, such as Cr-rich borides, phosphides, and Cr- and Ti-rich carbides