Geotechnical properties of tire-cohesive clayey soil mixtures as a fill material

Geotechnical properties of pure fine and coarse grained tire-chips and their mixtures (10, 20, 30, 40 and 50%) with a cohesive clayey soil were investigated through a series of soil mechanical tests in order to investigate possibilities of their usage as a lightweight fill material. Grain size and Atterberg limits analysis, permeability, direct shear and compaction tests were performed on the clayey soil, tire chips (both fine and coarse) alone and their mixtures. The results indicate that the use of used tire-chips mixed with clayey soils as a fill material is possible. The mixtures up to 20% coarse grained tire-chips and 30% fine grained tire-chips can be used above ground water tables where low weight, low permeability and high strength are needed in fills such as highway embankments, bridge abutments and backfills behind retaining structures especially when they are to be built on weak foundation soils with low bearing capacity and high settlement problems. They should not be used where drainage is needed to prevent the development of pore pressures during loading of fills under saturated conditions. In these cases, they may, however, be used by mixing with high permeability material such as sand and gravel. © 2006 Elsevier B.V. All rights reserved.FBE.97YL.96Part of this study was financially supported by the Çukurova University Research Foundation (Project No: FBE.97YL.96). The authors thank two anonymous Engineering Geology reviewers for their critical review of the manuscript. Their invaluable comments improved the manuscript considerably. We would also like to thank Aysun Serin and Hikmet Senbayrak for their help in soil mechanics tests and Mustafa Laman for providing unlimited access to the soil mechanics laboratory of the Civil Engineering Deparment at Çukurova University