Simple inlet devices and their influence on thermal stratification in a hot water storage tank

[EN] Thermal energy storage is a technology used mostly in buildings and industries in order to preserve thermal energy so that the stored energy can be used at a later time. Thermal stratification during the charge process in a cylindrical water tank was investigated using tools of Computational Fluid Dynamics (CFD). Simulations were validated by means of experimental measurements of time-dependent temperature profiles. The results showed that the model was able to adequately capture the experimental temperature evolution in the tank for all the validation cases. Once validated the model, simple modifications of the usual inlet devices and inflow rate by CFD techniques were accomplished with the intention of improving the tank performance. It was found that the modifications of the simulated inlet devices affected the stratification level. This could lead to improve designs and optimize system efficiency. The analyses confirmed numerically the results obtained experimentally, and it was evidenced that a sintered bronze conical diffuser can improve stratification compared to a conventional bronze elbow inlet. Therefore, CFD techniques proved to be quite a valuable complement of experimental studies. The use of low inflow, smooth out inlet velocity and operate inflow upwards near the top of the tank enhanced stratification. (C) 2017 Published by Elsevier B.V.This research was supported by the Plan Nacional de I+D+i del Ministerio de Ciencia e Innovacion (ENE2009-13376). The authors would like to thank L.H. Sanchis for his valuable and constructive suggestions during the planning and development of this research.Moncho Esteve, IJ.; Gasque Albalate, M.; González Altozano, P.; Palau-Salvador, G. (2017). Simple inlet devices and their influence on thermal stratification in a hot water storage tank. Energy and Buildings. 150:625-638. https://doi.org/10.1016/j.enbuild.2017.06.01262563815