Fabrication of full density near-nanostructured cemented carbides by combination of VC/Cr3C2 addition and consolidation by SPS and HIP technologies

The aim of present work is to study the effect of VC and/or Cr3C2 in densification, microstructural development and mechanical behavior of nanocrystalline WC-12wt.%Co powders when they are sintered by spark plasma sintering (SPS) and hot isostatic pressing (HIP). The results were compared to those corresponding to conventional sintering in vacuum. The density, microstructure, X-ray diffraction, hardness and fracture toughness of the sintered materials were evaluated. Materials prepared by SPS exhibits full densification at lower temperature (1100 degrees C) and a shorter stay time (5 min), allowing the grain growth control. However, the effect of the inhibitors during SPS process is considerably lower than in conventional sintering. Materials prepared by HIP at 1100 degrees C and 30 min present full densification and a better control of microstructure in the presence of VC. The added amount of VC allows obtaining homogeneous microstructures with an average grain size of 120 nm. The hardness and fracture toughness values obtained were about 2100 HV30 and close to 10 MPa m(1/)2, respectively. (C) 2010 Elsevier Ltd. All rights reserved.The work is supported financially by the Spanish Ministry of Science and Innovation by means of the project MAT 2006-12945-C03-C02 and MAT 2009-14144-C03-C02.Bonache Bezares, V.; Salvador Moya, MD.; Fernández Valdés, A.; Borrell Tomás, MA. (2011). Fabrication of full density near-nanostructured cemented carbides by combination of VC/Cr3C2 addition and consolidation by SPS and HIP technologies. International Journal of Refractory Metals and Hard Materials. 29(2):202-208. https://doi.org/10.1016/j.ijrmhm.2010.10.00720220829